arm64: dts: ipq8074: add crypto nodes
PATCH 1/2 arm64: dts: ipq8074: add crypto nodes
IPQ8074 uses Qualcom QCE crypto engine v5.1
which is already supported.
So simply add nodes for its DMA and QCE itself.
Signed-off-by Robert Marko <[email protected]>
--- arch/arm64/boot/dts/qcom/ipq8074.dtsi | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+)
arch/arm64/boot/dts/qcom/ipq8074.dtsi +24 -0
@@ -197,6 +197,30 @@ pcie_phy1: phy@8e000 { status = "disabled"; }; + cryptobam: dma@704000 { + compatible = "qcom,bam-v1.7.0"; + reg = <0x00704000 0x20000>; + interrupts = <GIC_SPI 207 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&gcc GCC_CRYPTO_AHB_CLK>; + clock-names = "bam_clk"; + #dma-cells = <1>; + qcom,ee = <1>; + qcom,controlled-remotely = <1>; + status = "disabled"; + }; + + crypto: crypto@73a000 { + compatible = "qcom,crypto-v5.1"; + reg = <0x0073a000 0x6000>; + clocks = <&gcc GCC_CRYPTO_AHB_CLK>, + <&gcc GCC_CRYPTO_AXI_CLK>, + <&gcc GCC_CRYPTO_CLK>; + clock-names = "iface", "bus", "core"; + dmas = <&cryptobam 2>, <&cryptobam 3>; + dma-names = "rx", "tx"; + status = "disabled"; + }; + tlmm: pinctrl@1000000 { compatible = "qcom,ipq8074-pinctrl"; reg = <0x01000000 0x300000>;
Signature · 1 line
2.31.1
PATCH 2/2 arm64: dts: ipq8074: add PRNG node
PRNG insinde of IPQ8074 is already supported,
so simply add the node for it.
Signed-off-by Robert Marko <[email protected]>
--- arch/arm64/boot/dts/qcom/ipq8074.dtsi | 8 ++++++++ 1 file changed, 8 insertions(+)
arch/arm64/boot/dts/qcom/ipq8074.dtsi +8 -0
@@ -197,6 +197,14 @@ pcie_phy1: phy@8e000 { status = "disabled"; }; + prng: rng@e3000 { + compatible = "qcom,prng-ee"; + reg = <0x000e3000 0x1000>; + clocks = <&gcc GCC_PRNG_AHB_CLK>; + clock-names = "core"; + status = "disabled"; + }; + cryptobam: dma@704000 { compatible = "qcom,bam-v1.7.0"; reg = <0x00704000 0x20000>;
Signature · 1 line
2.31.1