Skip to contentSkip to conversation

rockchip: board: Fix bug for clk driver for OGA

PATCH In review Chris Morgan 2 participants 5 messages Aug 5, 2021 – Oct 15, 2021

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

cover rockchip: board: Fix bug for clk driver for OGA

From: Chris Morgan <[email protected]>

This series is to fix a problem with probing the clk_px30 driver that began with commit 92f1e9a4b31c ("clk: Detect failure to set defaults"). The driver fails to probe because 2 clocks are unsupported. One clock (the cpll) was simple to add to the driver and the other clock (the GPU) is not used in U-Boot so was removed from the U-Boot specific device tree. With these changes the clk driver probes again successfully. Note that without this fix no devices that depend on the clk driver are able to probe as well (such as the SD card, the SPI bus, etc) so the device fails to boot.

Chris Morgan (2):
rockchip: px30: add support for setting cpll clock
rockchip: board: remove SCLK_GPU from U-Boot DT

 arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi | 10 ++++++++++
 drivers/clk/rockchip/clk_px30.c            |  3 +++
 2 files changed, 13 insertions(+)
Signature · 1 line
2.25.1
#1 lore raw

PATCH 1/2 rockchip: px30: add support for setting cpll clock

From: Chris Morgan <[email protected]>

Starting with commit 92f1e9a4b31c ("clk: Detect failure to set defaults") the clk driver for the PX30 for the Odroid Go Advance would no longer probe correctly, because setting the cpll and gpu clocks are not supported with the clk_px30 U-Boot driver. This adds support for setting the cpll clock to the clk_px30 driver. Another patch will update the U-Boot specific device-tree to remove the GPU clock which is not used by U-Boot.

---
 drivers/clk/rockchip/clk_px30.c | 3 +++
 1 file changed, 3 insertions(+)
drivers/clk/rockchip/clk_px30.c +3 -0
index 6b746f4c65..89784f9aa1 100644
@@ -1262,6 +1262,9 @@ static ulong px30_clk_set_rate(struct clk *clk, ulong rate)
 	case PLL_NPLL:
 		ret = px30_clk_set_pll_rate(priv, NPLL, rate);
 		break;
+	case PLL_CPLL:
+		ret = px30_clk_set_pll_rate(priv, CPLL, rate);
+		break;
 	case ARMCLK:
 		ret = px30_armclk_set_clk(priv, rate);
 		break;
Signature · 1 line
2.25.1
Reviewed-by on v1 1/2
#2 lore raw

Re: [PATCH 1/2] rockchip: px30: add support for setting cpll clock

Thanks,
- Kever

Quoted 33 lines · Chris Morgan <[email protected]> 于2021年8月6日周五 上午12:49写道:

From: Chris Morgan <[email protected]>

Starting with commit 92f1e9a4b31c ("clk: Detect failure to set defaults") the clk driver for the PX30 for the Odroid Go Advance would no longer probe correctly, because setting the cpll and gpu clocks are not supported with the clk_px30 U-Boot driver. This adds support for setting the cpll clock to the clk_px30 driver. Another patch will update the U-Boot specific device-tree to remove the GPU clock which is not used by U-Boot.

---
 drivers/clk/rockchip/clk_px30.c | 3 +++
 1 file changed, 3 insertions(+)
drivers/clk/rockchip/clk_px30.c +3 -1
index 6b746f4c65..89784f9aa1 100644
@@ -1262,6 +1262,9 @@ static ulong px30_clk_set_rate(struct clk *clk, ulong rate)
        case PLL_NPLL:
                ret = px30_clk_set_pll_rate(priv, NPLL, rate);
                break;
+       case PLL_CPLL:
+               ret = px30_clk_set_pll_rate(priv, CPLL, rate);
+               break;
        case ARMCLK:
                ret = px30_armclk_set_clk(priv, rate);
                break;
--

2.25.1

#3 lore raw

PATCH 2/2 rockchip: board: remove SCLK_GPU from U-Boot DT

In reply to Chris Morgan

From: Chris Morgan <[email protected]>

Starting with commit 92f1e9a4b31c ("clk: Detect failure to set defaults") the clk driver for the PX30 would fail to probe for the Odroid Go Advance. This patch is to remove the clock for the GPU from the U-Boot specific devicetree, as that clock is not supported by the U-Boot clk_px30 driver.

---
 arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)
arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi +10 -0
index 00767d2abd..c330286bc5 100644
@@ -9,8 +9,18 @@
 	};
 };
 
+/* U-Boot clk driver for px30 cannot set GPU_CLK */
 &cru {
 	u-boot,dm-pre-reloc;
+	assigned-clocks = <&cru PLL_NPLL>,
+		<&cru ACLK_BUS_PRE>, <&cru ACLK_PERI_PRE>,
+		<&cru HCLK_BUS_PRE>, <&cru HCLK_PERI_PRE>,
+		<&cru PCLK_BUS_PRE>, <&cru PLL_CPLL>;
+
+	assigned-clock-rates = <1188000000>,
+		<200000000>, <200000000>,
+		<150000000>, <150000000>,
+		<100000000>, <17000000>;
 };
 
 &dmc {
Signature · 1 line
2.25.1
Reviewed-by on v1 2/2
#4 lore raw

Re: [PATCH 2/2] rockchip: board: remove SCLK_GPU from U-Boot DT

Thanks,
- Kever

Quoted 40 lines · Chris Morgan <[email protected]> 于2021年8月6日周五 上午12:49写道:

From: Chris Morgan <[email protected]>

Starting with commit 92f1e9a4b31c ("clk: Detect failure to set defaults") the clk driver for the PX30 would fail to probe for the Odroid Go Advance. This patch is to remove the clock for the GPU from the U-Boot specific devicetree, as that clock is not supported by the U-Boot clk_px30 driver.

---
 arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi | 10 ++++++++++
 1 file changed, 10 insertions(+)
arch/arm/dts/rk3326-odroid-go2-u-boot.dtsi +10 -1
index 00767d2abd..c330286bc5 100644
@@ -9,8 +9,18 @@
        };
 };
 
+/* U-Boot clk driver for px30 cannot set GPU_CLK */
 &cru {
        u-boot,dm-pre-reloc;
+       assigned-clocks = <&cru PLL_NPLL>,
+               <&cru ACLK_BUS_PRE>, <&cru ACLK_PERI_PRE>,
+               <&cru HCLK_BUS_PRE>, <&cru HCLK_PERI_PRE>,
+               <&cru PCLK_BUS_PRE>, <&cru PLL_CPLL>;
+
+       assigned-clock-rates = <1188000000>,
+               <200000000>, <200000000>,
+               <150000000>, <150000000>,
+               <100000000>, <17000000>;
 };
 
 &dmc {
--

2.25.1