imx8mm-evk: Generate a single bootable flash.bin again
Subsystems (2)
PATCH v2 1/1 imx8mm-evk: Generate a single bootable flash.bin again
After the conversion to binman in commit 8996e6b7c6a1 ("imx8mm_evk: switch to use binman to pack images"), it is necessary to flash both flash.bin and u-boot.itb to get a bootable system. Prior to this commit, only flash.bin was needed.
Such new requirement breaks existing distro mechanisms to generate the final binary because the extra u-boot.itb is now required.
Generate a final flash.bin that can be used again as a single bootable binary to keep the original behavior.
After this change the SPL binary is called spl.bin, which is a more descriptive name for its purpose, and can still be used standalone (for example, for secure boot purposes).
Also update imx8mm_evk.rst to remove the u-boot.itb copy step.
---
Changes since v1:
- Update the readme (Tim)
arch/arm/dts/imx8mm-evk-u-boot.dtsi | 17 ++++++++++++++++- doc/board/freescale/imx8mm_evk.rst | 1 - 2 files changed, 16 insertions(+), 2 deletions(-)
arch/arm/dts/imx8mm-evk-u-boot.dtsi +16 -1
@@ -150,7 +150,7 @@ }; - flash { + spl { mkimage { args = "-n spl/u-boot-spl.cfgout -T imx8mimage -e 0x7e1000";
@@ -217,4 +217,19 @@ }; }; }; + + imx-boot { + filename = "flash.bin"; + pad-byte = <0x00>; + + spl: blob-ext@1 { + offset = <0x0>; + filename = "spl.bin"; + }; + + uboot: blob-ext@2 { + offset = <0x57c00>; + filename = "u-boot.itb"; + }; + }; };
doc/board/freescale/imx8mm_evk.rst +0 -1
@@ -50,7 +50,6 @@ Burn the flash.bin to MicroSD card offset 33KB: .. code-block:: bash $sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=33 conv=notrunc - $sudo dd if=u-boot.itb of=/dev/sdc bs=1024 seek=384 conv=sync Boot ----
Signature · 1 line
2.25.1