arm: dts: imx8mp: Generate single bootable binary
Subsystems (2)
PATCH v2 1/1 arm: dts: imx8mp: Generate single bootable binary
binman conversion made flashing flash.bin and u-boot.itb necessary. Update binman config to create a single flash.bin image again.
This updates imx8mp_evk and phyCORE-i.MX8MP as they share the same binman config.
Updated also imx8mp_evk documentation.
Tested on phyCORE-i.MX8MP.
---
Changes in v2:
- Added filename to spl node
- Use u-boot-spl-ddr.bin in the LOADER section
arch/arm/dts/imx8mp-u-boot.dtsi | 19 ++++++++++++++++++- .../imx8mp_evk/imximage-8mp-lpddr4.cfg | 2 +- .../phytec/phycore_imx8mp/imximage-8mp-sd.cfg | 2 +- doc/board/nxp/imx8mp_evk.rst | 1 - 4 files changed, 20 insertions(+), 4 deletions(-)
arch/arm/dts/imx8mp-u-boot.dtsi +18 -1
@@ -82,7 +82,9 @@ }; }; - flash { + spl { + filename = "spl.bin"; + mkimage { args = "-n spl/u-boot-spl.cfgout -T imx8mimage -e 0x920000";
@@ -149,4 +151,19 @@ }; }; }; + + imx-boot { + filename = "flash.bin"; + pad-byte = <0x00>; + + spl: blob-ext@1 { + filename = "spl.bin"; + offset = <0x0>; + }; + + uboot: blob-ext@2 { + filename = "u-boot.itb"; + offset = <0x58000>; + }; + }; };
board/freescale/imx8mp_evk/imximage-8mp-lpddr4.cfg +1 -1
@@ -7,4 +7,4 @@ ROM_VERSION v2 BOOT_FROM sd -LOADER mkimage.flash.mkimage 0x920000 +LOADER u-boot-spl-ddr.bin 0x920000
board/phytec/phycore_imx8mp/imximage-8mp-sd.cfg +1 -1
@@ -7,4 +7,4 @@ ROM_VERSION v2 BOOT_FROM sd -LOADER mkimage.flash.mkimage 0x920000 +LOADER u-boot-spl-ddr.bin 0x920000
doc/board/nxp/imx8mp_evk.rst +0 -1
@@ -52,7 +52,6 @@ Burn the flash.bin to the MicroSD card at offset 32KB: .. code-block:: bash $sudo dd if=build/flash.bin of=/dev/sd[x] bs=1K seek=32 conv=notrunc; sync - $sudo dd if=build/u-boot.itb of=/dev/sd[x] bs=1K seek=384 conv=notrunc; sync Boot ----
Signature · 1 line
2.25.1
PATCH v2 1/1 arm: dts: imx8mp: Generate single bootable binary
Quoted 10 lines
binman conversion made flashing flash.bin
and u-boot.itb necessary. Update binman config
to create a single flash.bin image again.
This updatesimx8mp_evkand phyCORE-i.MX8MP as they share the same binman config.
Updated alsoimx8mp_evkdocumentation.
Tested on phyCORE-i.MX8MP.Signed-off-by Teresa Remmet <[email protected]>Reviewed-by Fabio Estevam <[email protected]>Reviewed-by Heiko Schocher <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================