dt-bindings: mfd: brcm,cru: fix pin controller nodename
Subsystems (3)
PATCH 1/1 dt-bindings: mfd: brcm,cru: fix pin controller nodename
From: Rafał Miłecki <[email protected]>
Replace "pin-controller@" with "pinctrl@" to match new pinctrl binding
requirement. This will fix:Documentation/devicetree/bindings/mfd/brcm,cru.example.dt.yaml: cru-bus@1800c100: 'pinctrl@1c0' does not match any of the regexes: '^clock-controller@[a-f0-9]+$', '^phy@[a-f0-9]+$', '^pin-controller@[a-f0-9]+$', '^syscon@[a-f0-9]+$', '^thermal@[a-f0-9]+$', 'pinctrl-[0-9]+'
From schema: Documentation/devicetree/bindings/mfd/brcm,cru.yaml
--- Documentation/devicetree/bindings/mfd/brcm,cru.yaml | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/devicetree/bindings/mfd/brcm,cru.yaml +2 -2
@@ -39,7 +39,7 @@ patternProperties: '^phy@[a-f0-9]+$': $ref: ../phy/bcm-ns-usb2-phy.yaml - '^pin-controller@[a-f0-9]+$': + '^pinctrl@[a-f0-9]+$': $ref: ../pinctrl/brcm,ns-pinmux.yaml '^syscon@[a-f0-9]+$':
@@ -94,7 +94,7 @@ examples: reg = <0x180 0x4>; }; - pin-controller@1c0 { + pinctrl@1c0 { compatible = "brcm,bcm4708-pinmux"; reg = <0x1c0 0x24>; reg-names = "cru_gpio_control";
Signature · 1 line
2.31.1
Quoted 7 lines · Rafał Miłecki
From: Rafał Miłecki <[email protected]>
Replace "pin-controller@" with "pinctrl@" to match new pinctrl binding
requirement. This will fix:Documentation/devicetree/bindings/mfd/brcm,cru.example.dt.yaml: cru-bus@1800c100: 'pinctrl@1c0' does not match any of the regexes: '^clock-controller@[a-f0-9]+$', '^phy@[a-f0-9]+$', '^pin-controller@[a-f0-9]+$', '^syscon@[a-f0-9]+$', '^thermal@[a-f0-9]+$', 'pinctrl-[0-9]+'
From schema:Documentation/devicetree/bindings/mfd/brcm,cru.yaml
Quoted 6 lines
Reported-by Rob Herring <[email protected]>Signed-off-by Rafał Miłecki <[email protected]>--- Documentation/devicetree/bindings/mfd/brcm,cru.yaml | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)