dt-bindings: arm: Allow 32-bit 'cpu-release-addr' values
Rob Herring
maintainerPATCH 1/1 dt-bindings: arm: Allow 32-bit 'cpu-release-addr' values
While the DT Spec says 'cpu-release-addr' is always 64-bit, some 32-bit Arm DTs used a 32-bit value. We're now stuck with those cases, so add uint32 as a valid type.
Signed-off-by Rob Herring <[email protected]>
--- Documentation/devicetree/bindings/arm/cpus.yaml | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
Documentation/devicetree/bindings/arm/cpus.yaml +5 -5
@@ -233,14 +233,14 @@ properties: - ti,am4372 cpu-release-addr: - $ref: '/schemas/types.yaml#/definitions/uint64' - + oneOf: + - $ref: '/schemas/types.yaml#/definitions/uint32' + - $ref: '/schemas/types.yaml#/definitions/uint64' description: + The DT specification defines this as 64-bit always, but some 32-bit Arm + systems have used a 32-bit value which must be supported. Required for systems that have an "enable-method" property value of "spin-table". - On ARM v8 64-bit systems must be a two cell - property identifying a 64-bit zero-initialised - memory location. cpu-idle-states: $ref: '/schemas/types.yaml#/definitions/phandle-array'
Signature · 1 line
2.32.0
Quoted 9 lines · Rob Herring
While the DT Spec says 'cpu-release-addr' is always 64-bit, some 32-bit Arm DTs used a 32-bit value. We're now stuck with those cases, so add uint32 as a valid type.
Signed-off-by Rob Herring <[email protected]>--- Documentation/devicetree/bindings/arm/cpus.yaml | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
Best regards,
Krzysztof