Skip to contentSkip to conversation

dt-bindings: arm: Allow 32-bit 'cpu-release-addr' values

PATCH In review Rob Herring 2 participants 2 messages Mar 3, 2022 Device tree bindings

lore
Share & tools
lore

Rob Herring

author maintainer
#0 lore raw

PATCH 1/1 dt-bindings: arm: Allow 32-bit 'cpu-release-addr' values

While the DT Spec says 'cpu-release-addr' is always 64-bit, some 32-bit Arm DTs used a 32-bit value. We're now stuck with those cases, so add uint32 as a valid type.

---
 Documentation/devicetree/bindings/arm/cpus.yaml | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
Documentation/devicetree/bindings/arm/cpus.yaml +5 -5
index 85a31ca862d0..ed04650291a8 100644
@@ -233,14 +233,14 @@ properties:
           - ti,am4372
 
   cpu-release-addr:
-    $ref: '/schemas/types.yaml#/definitions/uint64'
-
+    oneOf:
+      - $ref: '/schemas/types.yaml#/definitions/uint32'
+      - $ref: '/schemas/types.yaml#/definitions/uint64'
     description:
+      The DT specification defines this as 64-bit always, but some 32-bit Arm
+      systems have used a 32-bit value which must be supported.
       Required for systems that have an "enable-method"
         property value of "spin-table".
-      On ARM v8 64-bit systems must be a two cell
-        property identifying a 64-bit zero-initialised
-        memory location.
 
   cpu-idle-states:
     $ref: '/schemas/types.yaml#/definitions/phandle-array'
Signature · 1 line
2.32.0
Acked-by on v1 1/1
#1 lore raw
Quoted 9 lines · Rob Herring

While the DT Spec says 'cpu-release-addr' is always 64-bit, some 32-bit Arm DTs used a 32-bit value. We're now stuck with those cases, so add uint32 as a valid type.

---
 Documentation/devicetree/bindings/arm/cpus.yaml | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

Best regards,
Krzysztof