Skip to contentSkip to conversation

armv8/fsl-lsch3: Suppress spurious warning on Layerscape CPUs

PATCH New [email protected] 1 participant 1 message Mar 29, 2022 Arm (32-bit)

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 armv8/fsl-lsch3: Suppress spurious warning on Layerscape CPUs

From: Stephen Carlson <[email protected]>

NXP/Freescale Layerscape CPUs support high-speed serial interfaces (SERDES) that can be configured for the application. Interfaces not used by the application can be set to protocol 0 to turn them off and save power, but U-Boot would emit a warning that 0 was invalid for a SERDES protocol on boot. Replace the warning text with a notice that the SERDES is disabled.

---
 arch/arm/cpu/armv8/fsl-layerscape/fsl_lsch3_serdes.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)
arch/arm/cpu/armv8/fsl-layerscape/fsl_lsch3_serdes.c +7 -3
index fad7a93566..181bd9c1b4 100644
@@ -147,10 +147,14 @@ void serdes_init(u32 sd, u32 sd_addr, u32 rcwsr, u32 sd_prctl_mask,
 	cfg >>= sd_prctl_shift;
 
 	cfg = serdes_get_number(sd, cfg);
-	printf("Using SERDES%d Protocol: %d (0x%x)\n", sd + 1, cfg, cfg);
+	if (cfg == 0) {
+		printf("SERDES%d is disabled\n", sd + 1);
+	} else {
+		printf("Using SERDES%d Protocol: %d (0x%x)\n", sd + 1, cfg, cfg);
 
-	if (!is_serdes_prtcl_valid(sd, cfg))
-		printf("SERDES%d[PRTCL] = 0x%x is not valid\n", sd + 1, cfg);
+		if (!is_serdes_prtcl_valid(sd, cfg))
+			printf("SERDES%d[PRTCL] = 0x%x is not valid\n", sd + 1, cfg);
+	}
 
 	for (lane = 0; lane < SRDS_MAX_LANES; lane++) {
 		enum srds_prtcl lane_prtcl = serdes_get_prtcl(sd, cfg, lane);
Signature · 1 line
2.17.1