Skip to contentSkip to conversation

pci: imx: remove weak overrides no longer used

PATCH New Tim Harvey 2 participants 2 messages Apr 13, 2022 – Apr 22, 2022

Subsystems (3)
lore
Share & tools
lore

Tim Harvey

author
#0 lore raw

PATCH 1/1 pci: imx: remove weak overrides no longer used

There are no users of the imx6_pcie_toggle_power and imx6_pcie_toggle_reset weak overrides and as these functions are able to be handled now via dt properties lets remove these.

---
 arch/arm/include/asm/arch-mx6/sys_proto.h |  3 ---
 drivers/pci/pcie_imx.c                    | 10 ++--------
 2 files changed, 2 insertions(+), 11 deletions(-)
arch/arm/include/asm/arch-mx6/sys_proto.h +0 -3
index c7542e4b04e1..7845fa8e5693 100644
@@ -18,9 +18,6 @@
 #define is_usbotg_phy_active(void) (!(readl(USB_PHY0_BASE_ADDR + USBPHY_PWD) & \
 				   USBPHY_PWD_RXPWDRX))
 
-int imx6_pcie_toggle_power(struct udevice *vpcie);
-int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high);
-
 enum ldo_reg {
 	LDO_ARM,
 	LDO_SOC,
drivers/pci/pcie_imx.c +2 -8
index f8daedbce359..46ac01713ff7 100644
@@ -532,7 +532,7 @@ static int imx6_pcie_init_phy(void)
 	return 0;
 }
 
-__weak int imx6_pcie_toggle_power(struct udevice *vpcie)
+int imx6_pcie_toggle_power(struct udevice *vpcie)
 {
 #ifdef CONFIG_PCIE_IMX_POWER_GPIO
 	gpio_request(CONFIG_PCIE_IMX_POWER_GPIO, "pcie_power");
@@ -554,7 +554,7 @@ __weak int imx6_pcie_toggle_power(struct udevice *vpcie)
 	return 0;
 }
 
-__weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
+int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
 {
 	/*
 	 * See 'PCI EXPRESS BASE SPECIFICATION, REV 3.0, SECTION 6.6.1'
@@ -570,12 +570,6 @@ __weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
 	 * configuration file and the condition below will handle the rest
 	 * of the reset toggling.
 	 *
-	 * In case your #PERST toggling logic is more complex, for example
-	 * connected via CPLD or somesuch, you can override this function
-	 * in your board file and implement reset logic as needed. You must
-	 * not forget to wait at least 20 ms after de-asserting #PERST in
-	 * this case either though.
-	 *
 	 * In case your #PERST line of the PCIe EP device is not connected
 	 * at all, your design is broken and you should fix your design,
 	 * otherwise you will observe problems like for example the link
Signature · 1 line
2.17.1
#1 lore raw

PATCH 1/1 pci: imx: remove weak overrides no longer used

Quoted 5 lines

There are no users of the imx6_pcie_toggle_power and imx6_pcie_toggle_reset weak overrides and as these functions are able to be handled now via dt properties lets remove these.

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected]
=====================================================================