ARM: dts: imx6sl: Add a label for the cpu node
Subsystems (2)
Fabio Estevam
reviewerPATCH 1/1 ARM: dts: imx6sl: Add a label for the cpu node
Add a label for the cpu node, so that board devicetree files can reference to the CPU node.
This is useful for describing a PMIC voltage that supplies the CPU voltage.
For example:
&cpu0 {
cpu-supply = <&sw1_reg>;Signed-off-by Fabio Estevam <[email protected]>
--- arch/arm/boot/dts/imx6sl.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/imx6sl.dtsi +1 -1
@@ -50,7 +50,7 @@ cpus { #address-cells = <1>; #size-cells = <0>; - cpu@0 { + cpu0: cpu@0 { compatible = "arm,cortex-a9"; device_type = "cpu"; reg = <0x0>;
Signature · 7 lines
2.25.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 6 lines · Fabio Estevam
Add a label for the cpu node, so that board devicetree files can reference to the CPU node.
This is useful for describing a PMIC voltage that supplies the CPU voltage.
Quoted 6 lines
For example:
&cpu0 { cpu-supply = <&sw1_reg>;Signed-off-by Fabio Estevam <[email protected]>
Applied, thanks!
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel