Skip to contentSkip to conversation

mx6cuboxi: fix board detection while patching device-tree phy nodes

PATCH New Josua Mayer 2 participants 2 messages Jun 16, 2022 – Jul 25, 2022

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 mx6cuboxi: fix board detection while patching device-tree phy nodes

ft_board_setup relies on the board_type() function to optimize which phy nodes need to be enabled for Linux.
Add calls to setup and release the board-detect GPIOs.

Also fix the switch-case statement to only enable phy address 4 for Cubox and unknown devices.

Fixes 741ce308 ("mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS")
---
 board/solidrun/mx6cuboxi/mx6cuboxi.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)
board/solidrun/mx6cuboxi/mx6cuboxi.c +12 -1
index 42aa5cb63c..debf4f6a3b 100644
@@ -449,15 +449,26 @@ int ft_board_setup(void *fdt, struct bd_info *bd)
 	int node_phy0, node_phy1, node_phy4;
 	int ret, phy;
 	bool enable_phy0 = false, enable_phy1 = false, enable_phy4 = false;
+	enum board_type board;
+
+	// detect device
+	request_detect_gpios();
+	board = board_type();
+	free_detect_gpios();
 
 	// detect phy
 	phy = find_ethernet_phy();
 	if (phy == 0 || phy == 4) {
 		enable_phy0 = true;
-		switch (board_type()) {
+		switch (board) {
+		case HUMMINGBOARD:
+		case HUMMINGBOARD2:
+			/* atheros phy may appear only at address 0 */
+			break;
 		case CUBOXI:
 		case UNKNOWN:
 		default:
+			/* atheros phy may appear at either address 0 or 4 */
 			enable_phy4 = true;
 		}
 	} else if (phy == 1) {
Signature · 1 line
2.35.3
#1 lore raw

PATCH 1/1 mx6cuboxi: fix board detection while patching device-tree phy nodes

Quoted 7 lines

ft_board_setup relies on the board_type() function to optimize which phy nodes need to be enabled for Linux.
Add calls to setup and release the board-detect GPIOs.
Also fix the switch-case statement to only enable phy address 4 for Cubox and unknown devices.

Fixes 741ce308 ("mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS")

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected]
=====================================================================