i3c: update dw-i3c-master i3c_clk_cfg function
Subsystems (2)
PATCH v2 1/1 i3c: update dw-i3c-master i3c_clk_cfg function
Bus-speed could be default(12.5MHz) or defined by users in dts. Dw-i3c-master should not hard-code the initial speed to be I3C_BUS_TYP_I3C_SCL_RATE (12.5MHz)
And because of Synopsys's I3C controller limit (hcnt/lcnt register length) and core-clk provided, there is a limit to bus speed, too. For example, when core-clk is 250 MHz, the bus speed cannot be lowered below 1MHz.
Replace max with max_t.
Reported-by kernel test robot <[email protected]>
Tested: tested with an i3c sensor and captured with a logic analyzer.
Signed-off-by Jack Chen <[email protected]>
--- drivers/i3c/master/dw-i3c-master.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
drivers/i3c/master/dw-i3c-master.c +3 -2
@@ -531,7 +531,7 @@ static int dw_i3c_clk_cfg(struct dw_i3c_master *master)if (hcnt <SCL_I3C_TIMING_CNT_MIN ) hcnt =SCL_I3C_TIMING_CNT_MIN ; - lcnt =DIV_ROUND_UP (core_rate,I3C_BUS_TYP_I3C_SCL_RATE ) - hcnt; + lcnt =DIV_ROUND_UP (core_rate, master->base.bus.scl_rate.i3c) - hcnt;if (lcnt <SCL_I3C_TIMING_CNT_MIN ) lcnt =SCL_I3C_TIMING_CNT_MIN ;
@@ -541,7 +541,8 @@ static int dw_i3c_clk_cfg(struct dw_i3c_master *master)if (!(readl (master->regs +DEVICE_CTRL ) &DEV_CTRL_I2C_SLAVE_PRESENT ))writel (BUS_I3C_MST_FREE (lcnt), master->regs +BUS_FREE_TIMING ); - lcnt =DIV_ROUND_UP (I3C_BUS_TLOW_OD_MIN_NS , core_period); + lcnt =max_t (u8, +DIV_ROUND_UP (I3C_BUS_TLOW_OD_MIN_NS , core_period), lcnt); scl_timing =SCL_I3C_TIMING_HCNT (hcnt) |SCL_I3C_TIMING_LCNT (lcnt);writel (scl_timing, master->regs +SCL_I3C_OD_TIMING );
Signature · 1 line
2.39.1.581.gbfd45094c4-goog