PCI: Disable AER & DPC on suspend
Subsystems (4)
v9 cover PCI: Disable AER & DPC on suspend
From: Bjorn Helgaas <[email protected]>
This is an old series from Kai-Heng that I didn't handle soon enough. The intent is to fix several suspend/resume issues:
- Spurious wakeup from s2idle
(https://bugzilla.kernel.org/show_bug.cgi?id=216295)
- Steam Deck doesn't resume after suspend
(https://bugzilla.kernel.org/show_bug.cgi?id=218090)
- Unexpected ACS error and DPC event when resuming after suspend
(https://bugzilla.kernel.org/show_bug.cgi?id=209149)
It seems that a glitch when the link is powered down during suspend causes errors to be logged by AER. When AER is enabled, this causes an AER interrupt, and if that IRQ is shared with PME, it may cause a spurious wakeup.
Also, errors logged during link power-down and power-up seem to cause unwanted error reporting during resume.
This series disables AER interrupts, DPC triggering, and DPC interrupts during suspend. On resume, it clears AER and DPC error status before re-enabling their interrupts.
I added a couple cosmetic changes for the v9, but this is essentially all Kai-Heng's work. I'm just posting it as a v9 because I failed to act on this earlier.
Bjorn
v9:
- Drop pci_ancestor_pr3_present() and pm_suspend_via_firmware; do it unconditionally
- Clear DPC status before re-enabling DPC interrupt
v8: https://lore.kernel.org/r/[email protected]
- Wording.
- Add more bug reports.
v7:
- Wording.
- Disable AER completely (again) if power will be turned off
- Disable DPC completely (again) if power will be turned off
v6: https://lore.kernel.org/r/[email protected]
v5: https://lore.kernel.org/r/[email protected]
- Wording.
v4: https://lore.kernel.org/r/[email protected]
v3: https://lore.kernel.org/r/[email protected]
- Correct subject.
v2: https://lore.kernel.org/r/[email protected]
- Only disable AER IRQ.
- No more AER check on PME IRQ#.
- Use AER helper.
- Only disable DPC IRQ.
- No more DPC check on PME IRQ#.
v1: https://lore.kernel.org/r/[email protected]
Kai-Heng Feng (2):
PCI/AER: Disable AER service on suspend
PCI/DPC: Disable DPC service on suspend
drivers/pci/pcie/aer.c | 18 +++++++++++++ drivers/pci/pcie/dpc.c | 60 +++++++++++++++++++++++++++++++++--------- 2 files changed, 66 insertions(+), 12 deletions(-)
Signature · 1 line
2.34.1
PATCH v9 1/2 PCI/AER: Disable AER service on suspend
From: Kai-Heng Feng <[email protected]>
If the link is powered off during suspend, electrical noise may cause errors that are logged via AER. If the AER interrupt is enabled and shares an IRQ with PME, that causes a spurious wakeup during suspend.
Disable the AER interrupt during suspend to prevent this. Clear error status before re-enabling IRQ interrupts during resume so we don't get an interrupt for errors that occurred during the suspend/resume process.
--- drivers/pci/pcie/aer.c | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)
drivers/pci/pcie/aer.c +18 -0
@@ -1497,6 +1497,22 @@ static int aer_probe(struct pcie_device *dev)return 0 ; } +static int aer_suspend (struct pcie_device *dev) +{ +struct aer_rpc *rpc =get_service_data (dev); + +aer_disable_rootport (rpc); +return 0 ; +} + +static int aer_resume (struct pcie_device *dev) +{ +struct aer_rpc *rpc =get_service_data (dev); + +aer_enable_rootport (rpc); +return 0 ; +} +/** * aer_root_reset - reset Root Port hierarchy, RCEC, or RCiEP * @dev: pointer to Root Port, RCEC, or RCiEP
@@ -1561,6 +1577,8 @@ static struct pcie_port_service_driver aerdriver = { .service = PCIE_PORT_SERVICE_AER, .probe = aer_probe, + .suspend = aer_suspend, + .resume = aer_resume, .remove = aer_remove, };
Signature · 1 line
2.34.1
PATCH v9 2/2 PCI/DPC: Disable DPC service on suspend
In reply to Bjorn HelgaasFrom: Kai-Heng Feng <[email protected]>
If the link is powered off during suspend, electrical noise may cause errors that trigger DPC. If the DPC interrupt is enabled and shares an IRQ with PME, that causes a spurious wakeup during suspend.
Disable DPC triggering and the DPC interrupt during suspend to prevent this. Clear DPC interrupt status before re-enabling DPC interrupts during resume so we don't get an interrupt for errors that occurred during the suspend/resume process.
--- drivers/pci/pcie/dpc.c | 60 +++++++++++++++++++++++++++++++++--------- 1 file changed, 48 insertions(+), 12 deletions(-)
drivers/pci/pcie/dpc.c +48 -12
@@ -412,13 +412,44 @@ void pci_dpc_init(struct pci_dev *pdev) } } +static void dpc_enable (struct pcie_device *dev) +{ +struct pci_dev *pdev = dev->port; +int dpc = pdev->dpc_cap; +u16 ctl; + +/* +* Clear DPC Interrupt Status so we don't get an interrupt for an +* old event when setting DPC Interrupt Enable. +*/ +pci_write_config_word (pdev, dpc +PCI_EXP_DPC_STATUS , +PCI_EXP_DPC_STATUS_INTERRUPT ); + +pci_read_config_word (pdev, dpc +PCI_EXP_DPC_CTL , &ctl); + ctl &= ~PCI_EXP_DPC_CTL_EN_MASK ; + ctl |=PCI_EXP_DPC_CTL_EN_FATAL |PCI_EXP_DPC_CTL_INT_EN ; +pci_write_config_word (pdev, dpc +PCI_EXP_DPC_CTL , ctl); +} + +static void dpc_disable (struct pcie_device *dev) +{ +struct pci_dev *pdev = dev->port; +int dpc = pdev->dpc_cap; +u16 ctl; + +/* Disable DPC triggering and DPC interrupts */ +pci_read_config_word (pdev, dpc +PCI_EXP_DPC_CTL , &ctl); + ctl &= ~(PCI_EXP_DPC_CTL_EN_FATAL |PCI_EXP_DPC_CTL_INT_EN ); +pci_write_config_word (pdev, dpc +PCI_EXP_DPC_CTL , ctl); +} +#define FLAG (x, y) (((x) & (y)) ? '+' : '-')static int dpc_probe (struct pcie_device *dev) {struct pci_dev *pdev = dev->port;struct device *device = &dev->device;int status; -u16 ctl, cap; +u16 cap;if (!pcie_aer_is_native (pdev) && !pcie_ports_dpc_native)return -ENOTSUPP ;
@@ -433,11 +464,7 @@ static int dpc_probe(struct pcie_device *dev) }pci_read_config_word (pdev, pdev->dpc_cap +PCI_EXP_DPC_CAP , &cap); - -pci_read_config_word (pdev, pdev->dpc_cap +PCI_EXP_DPC_CTL , &ctl); - ctl &= ~PCI_EXP_DPC_CTL_EN_MASK ; - ctl |=PCI_EXP_DPC_CTL_EN_FATAL |PCI_EXP_DPC_CTL_INT_EN ; -pci_write_config_word (pdev, pdev->dpc_cap +PCI_EXP_DPC_CTL , ctl); +dpc_enable (dev);pci_info (pdev,"enabled with IRQ %d\n" , dev->irq); pci_info(pdev, "error containment capabilities: Int Msg #%d, RPExt%c PoisonedTLP%c SwTrigger%c RP PIO Log %d, DL_ActiveErr%c\n",
@@ -450,14 +477,21 @@ static int dpc_probe(struct pcie_device *dev)return status; } +static int dpc_suspend (struct pcie_device *dev) +{ +dpc_disable (dev); +return 0 ; +} + +static int dpc_resume (struct pcie_device *dev) +{ +dpc_enable (dev); +return 0 ; +} +static void dpc_remove (struct pcie_device *dev) { -struct pci_dev *pdev = dev->port; -u16 ctl; - -pci_read_config_word (pdev, pdev->dpc_cap +PCI_EXP_DPC_CTL , &ctl); - ctl &= ~(PCI_EXP_DPC_CTL_EN_FATAL |PCI_EXP_DPC_CTL_INT_EN ); -pci_write_config_word (pdev, pdev->dpc_cap +PCI_EXP_DPC_CTL , ctl); +dpc_disable (dev); }static struct pcie_port_service_driver dpcdriver = {
@@ -465,6 +499,8 @@ static struct pcie_port_service_driver dpcdriver = { .port_type = PCIE_ANY_PORT, .service = PCIE_PORT_SERVICE_DPC, .probe = dpc_probe, + .suspend = dpc_suspend, + .resume = dpc_resume, .remove = dpc_remove, };
Signature · 1 line
2.34.1
Quoted 69 lines · Bjorn Helgaas
From: Bjorn Helgaas <[email protected]>
This is an old series from Kai-Heng that I didn't handle soon enough. The intent is to fix several suspend/resume issues:
- Spurious wakeup from s2idle
(https://bugzilla.kernel.org/show_bug.cgi?id=216295)- Steam Deck doesn't resume after suspend
(https://bugzilla.kernel.org/show_bug.cgi?id=218090)- Unexpected ACS error and DPC event when resuming after suspend
(https://bugzilla.kernel.org/show_bug.cgi?id=209149)It seems that a glitch when the link is powered down during suspend causes errors to be logged by AER. When AER is enabled, this causes an AER interrupt, and if that IRQ is shared with PME, it may cause a spurious wakeup.
Also, errors logged during link power-down and power-up seem to cause unwanted error reporting during resume.
This series disables AER interrupts, DPC triggering, and DPC interrupts during suspend. On resume, it clears AER and DPC error status before re-enabling their interrupts.
I added a couple cosmetic changes for the v9, but this is essentially all Kai-Heng's work. I'm just posting it as a v9 because I failed to act on this earlier.
Bjorn
v9:
- Droppci_ancestor_pr3_present()andpm_suspend_via_firmware; do it unconditionally
- Clear DPC status before re-enabling DPC interruptv8: https://lore.kernel.org/r/[email protected]
- Wording.
- Add more bug reports.v7:
- Wording.
- Disable AER completely (again) if power will be turned off
- Disable DPC completely (again) if power will be turned offv6: https://lore.kernel.org/r/[email protected]
v5: https://lore.kernel.org/r/[email protected]
- Wording.v4: https://lore.kernel.org/r/[email protected]
v3: https://lore.kernel.org/r/[email protected]
- Correct subject.v2: https://lore.kernel.org/r/[email protected]
- Only disable AER IRQ.
- No more AER check on PME IRQ#.
- Use AER helper.
- Only disable DPC IRQ.
- No more DPC check on PME IRQ#.v1: https://lore.kernel.org/r/[email protected]
Kai-Heng Feng (2):
PCI/AER: Disable AER service on suspend
PCI/DPC: Disable DPC service on suspend
Quoted 5 lines
drivers/pci/pcie/aer.c | 18 +++++++++++++ drivers/pci/pcie/dpc.c | 60 +++++++++++++++++++++++++++++++++--------- 2 files changed, 66 insertions(+), 12 deletions(-)--
Please feel free to add
to both patches in the series.
Thanks!