doc: thead: lpi4a: detail how to enable fastboot
PATCH 1/1 doc: thead: lpi4a: detail how to enable fastboot
Add that the "BOOT" button must be used
to switch the board to fastboot mode.
Signed-off-by Michael Opdenacker <[email protected]>
--- doc/board/thead/lpi4a.rst | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)
doc/board/thead/lpi4a.rst +4 -2
@@ -91,8 +91,10 @@ OpenSBI firmware and proper U-Boot. Booting ~~~~~~~ -u-boot-with-spl.bin should be loaded to SRAM through fastboot. Connect -the board to computer with Type-C cable and run +u-boot-with-spl.bin should be loaded to SRAM through fastboot. + +To put the board in fastboot mode, press and hold the ``BOOT`` button, +connect the board to the computer with a Type-C cable, release ``BOOT`` and run: .. code-block:: bash
---
base-commit: 8dbe57ba648648c4897717cebbc4505a8e0a8c23
change-id: 20260715-improve-lpi4a-doc-feed8191d37c
Best regards,
Signature · 1 line
Michael Opdenacker <[email protected]>
Quoted 30 lines · Michael Opdenacker
Add that the "BOOT" button must be used
to switch the board to fastboot mode.Signed-off-by Michael Opdenacker <[email protected]>--- doc/board/thead/lpi4a.rst | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)doc/board/thead/lpi4a.rst +4
-3@@ -91,8 +91,10 @@ OpenSBI firmware and proper U-Boot. Booting ~~~~~~~ -u-boot-with-spl.bin should be loaded to SRAM through fastboot. Connect -the board to computer with Type-C cable and run +u-boot-with-spl.bin should be loaded to SRAM through fastboot. + +To put the board in fastboot mode, press and hold the ``BOOT`` button, +connect the board to the computer with a Type-C cable, release ``BOOT`` and run: .. code-block:: bash ---base-commit:
8dbe57ba648648c4897717cebbc4505a8e0a8c23
change-id: 20260715-improve-lpi4a-doc-feed8191d37c
Quoted 4 lines
Best regards,
Signature · 1 line
Michael Opdenacker <[email protected]>
Reviewed-by Yao Zi <[email protected]>
Thanks, this is indeed more clear.
Regards,
Yao Zi