Skip to contentSkip to conversation

Problem of porting uClinux

U-Boot zhaozhoujun520 2 participants 2 messages Jan 4, 2009 – Jan 5, 2009

lore
Share & tools
lore
#0 lore raw

I am trying to port uClinux2.4 to my board [S3C44B0],but got a problem whitch I have no idea.

imagerom.bin was downloaded to 0xc100000 [RAM] and kenel can be run successfully by using command go 0xc100000.

Then I use mkimage -A arm -O linux -C gzip -a 0xc008000 -e 0xc008040 -d image.rom.gz uImage

kermit showed : (when I reset board after downloaded uImage to 0x20000 )
...
...
Verifying Checksum .....ok
Uncompressing Kenel Image ...Ok
##Loading Ramdisk Image at 000f0000....
Bad Magic Number

Quoted 1 line
Quoted 1 line
#1 lore raw

Hi Zhao,

Quoted 8 lines

kermit showed : (when I reset board after downloaded uImage to 0x20000 )
...
...
Verifying Checksum .....ok
Uncompressing Kenel Image ...Ok
##Loading Ramdisk Image at 000f0000....
Bad Magic Number

Quoted 1 line
Quoted 1 line

Is the root filesystem (ramdisk) in flash? The print

Quoted 2 lines

##Loading Ramdisk Image at 000f0000....
Bad Magic Number

denotes that loading the filesystem image from flash failed.

Regards,
Jayakrishnan