Allocating a frame buffer in memory
Hi,
I am trying to allocate a frame buffer for my LCD code. I think I understand how to set up the LCC controller in the Atmel AT91SAM9. So thats not the issue, at least not yet. I need to understand how UBoot allocates a block of memory for the buffer.
My TFT/LCD is 320x240 and in 24 bit mode, so 3 bytes per pixel. So I think I need 320x240x3 total bytes. Correct?
In my lib_arm/board.c file, there is the following:
#ifdef CONFIG_LCD
/* board init may have inited fb_base */
if (!gd->fb_base) {
# ifndef PAGE_SIZE
# define PAGE_SIZE 4096
# endif
/*
* reserve memory for LCD display (always full pages)
*/
/* bss_end is defined in the board-specific linker script */
addr = (_bss_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1);
size = lcd_setmem (addr);
gd->fb_base = addr;
}#endif /* CONFIG_LCD */
Then in lcd.c, there is lcd_setmem which displays:
Reserving 600k for LCD Framebuffer at: 0x23E91000
Even though I call lcd_setmem with an address of: 0x23F27000
Which is the address that I pass to the Atmel LCD controller DMA Address ? I have been using this: 0x23F27000
Thanks,
Steve
Signature · 2 lines
View this message in context: http://www.nabble.com/Allocating-a-frame-buffer-in-memory-tp22993711p22993711.html Sent from the Uboot - Users mailing list archive at Nabble.com.
Quoted 27 lines · Steven Zedeck
Hi,
I am trying to allocate a frame buffer for my LCD code. I think I understand how to set up the LCC controller in the Atmel AT91SAM9. So thats not the issue, at least not yet. I need to understand how UBoot allocates a block of memory for the buffer.My TFT/LCD is 320x240 and in 24 bit mode, so 3 bytes per pixel. So I think I need 320x240x3 total bytes. Correct?
In my
lib_arm/board.cfile, there is the following:#ifdef CONFIG_LCD /* board init may have inited fb_base */ if (!gd->fb_base) { # ifndef PAGE_SIZE # define PAGE_SIZE 4096 # endif /* * reserve memory for LCD display (always full pages) */ /* bss_end is defined in the board-specific linker script */ addr = (_bss_end + (PAGE_SIZE - 1)) & ~(PAGE_SIZE - 1); size = lcd_setmem (addr); gd->fb_base = addr; }#endif /*
CONFIG_LCD*/
Quoted 7 lines
Then in
lcd.c, there islcd_setmemwhich displays:
Reserving 600k for LCD Framebuffer at:0x23E91000Even though I call
lcd_setmemwith an address of:0x23F27000Which is the address that I pass to the Atmel LCD controller DMA Address ? I have been using this:
0x23F27000
on at91sam9 to specify the frambuffer base address you will just need to fill
gd->fb_base = AT91SAM9263_SRAM0_BASE;
or something else as done with the PSRAM for the pm9263
in your board init and specify your "vidinfo_t panel_info" that's all (maybe you will need to check the LCD pin out configuration)
Best Regards,
J.