dma: add dmaengine driver for Samsung s3c24xx SoCs
Quoted 29 lines · Tomasz Figa
Hi Linus, Heiko,
Quoted 25 lines · On Tuesday 14 of May 2013 14:47:19 Linus Walleij wrote:
Quoted 11 lines · Heiko St?bner
Conceptually the s3c24xx-dma feels like a distant relative of the pl08x with numerous virtual channels being mapped to a lot less physical ones. The driver therefore borrows a lot from the amba-pl08x driver in this regard. Functionality-wise the driver gains a memcpy ability in addition to the
slave_sgone.The driver currently only supports the "newer" SoCs which can use any physical channel for any dma slave. Support for the older SoCs where each channel only supports a subset of possible dma slaves will have to be added later.
Quoted 4 lines
Tested on a s3c2416-based board, memcpy using the dmatest module and
slave_sgpartially using the spi-s3c64xx driver.Signed-off-by Heiko Stuebner <[email protected]>So have I understood correctly if I assume that *some* S3C variants, i.e. this:
arch/arm/mach-s3c64xx/dma.chave a vanilla, unmodified, or just slightly modified PL08x block, while this DMAC is something probably based on the PL08x where some ASIC engineer has had a good time hacking around in the VHDL code to meet some feature requirements. Correct? Or plausible guess?
Quoted 4 lines
Quoted 1 line
Exactly *how* far away from the pl08x hardware is it?
AFAIK the DMAC of S3C24xx is completely different from PL08x. I think Heiko just meant that it uses similar concepts, like virtual channels.
Yes, right.
the DMAC of S3C24xx is completely different from PL08x.
As Heiko mentioned, the DMAC of S3C24xx is 'home grown' as other IPs of S3C24xx.
Best regards,
Jingoo Han