where is existing OpenPOWER checkstop handling support?
I know for OpenPOWER systems, there is some support to detect a system checkstop, wait some defined amount of time, then reset the machine. Could anyone point me to this code?
For OpenPOWER, the checkstop signal comes through GPIO.
GPIO monitor: https://github.com/openbmc/phosphor-gpio-monitor
Recipe:
https://github.com/openbmc/openbmc/blob/master/meta-openpower/recipes-phosphor/host/checkstop-monitor.bb
--
Best regards,
Artem Senichev
Quoted 5 lines · zshelle
I know for OpenPOWER systems, there is some support to detect a system checkstop, wait some defined amount of time, then reset the machine. Could anyone point me to this code?
Quoted 22 lines · Artem Senichev
For OpenPOWER, the checkstop signal comes through GPIO.
GPIO monitor: https://github.com/openbmc/phosphor-gpio-monitor [1]
--
Best regards,
Artem SenichevQuoted 5 lines · zshelle
I know for OpenPOWER systems, there is some support to detect a system
checkstop, wait some defined amount of time, then reset the machine.
Could anyone point me to this code?
Quoted 5 lines
Links:
------
[1] https://github.com/openbmc/phosphor-gpio-monitor
[2]
https://github.com/openbmc/openbmc/blob/master/meta-openpower/recipes-phosphor/host/checkstop-monitor.bb
Thank you. Now I just need to figure out how that works.