Skip to contentSkip to conversation

where is existing OpenPOWER checkstop handling support?

DISCUSSION zshelle 2 participants 3 messages Mar 1, 2019

lore
Share & tools
lore

zshelle

author
#0 lore raw

I know for OpenPOWER systems, there is some support to detect a system checkstop, wait some defined amount of time, then reset the machine. Could anyone point me to this code?

#1 lore raw

For OpenPOWER, the checkstop signal comes through GPIO.

GPIO monitor: https://github.com/openbmc/phosphor-gpio-monitor
Recipe:
https://github.com/openbmc/openbmc/blob/master/meta-openpower/recipes-phosphor/host/checkstop-monitor.bb

--
Best regards,
Artem Senichev

Quoted 5 lines · zshelle

I know for OpenPOWER systems, there is some support to detect a system checkstop, wait some defined amount of time, then reset the machine. Could anyone point me to this code?

author
#2 lore raw
Quoted 22 lines · Artem Senichev

For OpenPOWER, the checkstop signal comes through GPIO.

GPIO monitor: https://github.com/openbmc/phosphor-gpio-monitor [1]

Recipe:
https://github.com/openbmc/openbmc/blob/master/meta-openpower/recipes-phosphor/host/checkstop-monitor.bb
[2]

--
Best regards,
Artem Senichev

Quoted 5 lines · zshelle

I know for OpenPOWER systems, there is some support to detect a system
checkstop, wait some defined amount of time, then reset the machine.
Could anyone point me to this code?

Quoted 5 lines

Links:
------
[1] https://github.com/openbmc/phosphor-gpio-monitor
[2]
https://github.com/openbmc/openbmc/blob/master/meta-openpower/recipes-phosphor/host/checkstop-monitor.bb

Thank you. Now I just need to figure out how that works.