Power off 2.4.xx and ACPI / APM
Hi,
I've read some messages some time ago about problems related to ACPI. But I've not found the clue to my problem.
With kernel 2.2.19 and APM enabled, the power supply switches off while the message Power down appears.
With 2.4.x, nothing occurs. I've to enable ACPI too to have this behaviour.
But if I enable ACPI, I've a strange problem with my AX25 (hamradio) system :
all the frames I send on the radio network are _very_ long without any data in it. The watchdog of the card (DRSI : works with the scc driver),
switches the transmitter off after few seconds.
Any idea ?
----
Regards
Jean-Luc
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Quoted 4 lines · Jeff Garzik
Does this ACPI problem occur with 2.4.2-pre3? (patch available from ftp://ftp.fr.kernel.org/pub/linux/kernel/testing/)
Yep! The same problem with all the 2.4.x and 2.4.x-prey.
My .config is :CONFIG_PM=yCONFIG_ACPI=yCONFIG_APM=m
# CONFIG_APM_IGNORE_USER_SUSPEND is not set
# CONFIG_APM_DO_ENABLE is not setCONFIG_APM_CPU_IDLE=y
# CONFIG_APM_DISPLAY_BLANK is not setCONFIG_APM_RTC_IS_GMT=y
# CONFIG_APM_ALLOW_INTS is not set
# CONFIG_APM_REAL_MODE_POWER_OFF is not set
------
Regards
Jean-Luc
Quoted 5 lines
--
Jeff Garzik | "You see, in this world there's two kinds of Building 1024 | people, my friend: Those with loaded guns MandrakeSoft | and those who dig. You dig." --Blondie
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/