Skip to contentSkip to conversation

Power off 2.4.xx and ACPI / APM

DISCUSSION Jean-luc Coulon 1 participant 2 messages Feb 10, 2001 – Feb 11, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

I've read some messages some time ago about problems related to ACPI. But I've not found the clue to my problem.

With kernel 2.2.19 and APM enabled, the power supply switches off while the message Power down appears.

With 2.4.x, nothing occurs. I've to enable ACPI too to have this behaviour.

But if I enable ACPI, I've a strange problem with my AX25 (hamradio) system :
all the frames I send on the radio network are _very_ long without any data in it. The watchdog of the card (DRSI : works with the scc driver),

switches the transmitter off after few seconds.

Any idea ?

----

Regards

Jean-Luc

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/

#1 lore raw
Quoted 4 lines · Jeff Garzik

Does this ACPI problem occur with 2.4.2-pre3? (patch available from ftp://ftp.fr.kernel.org/pub/linux/kernel/testing/)

Yep! The same problem with all the 2.4.x and 2.4.x-prey.

My .config is :
CONFIG_PM=y
CONFIG_ACPI=y
CONFIG_APM=m
# CONFIG_APM_IGNORE_USER_SUSPEND is not set
# CONFIG_APM_DO_ENABLE is not set
CONFIG_APM_CPU_IDLE=y
# CONFIG_APM_DISPLAY_BLANK is not set
CONFIG_APM_RTC_IS_GMT=y
# CONFIG_APM_ALLOW_INTS is not set
# CONFIG_APM_REAL_MODE_POWER_OFF is not set

------

Regards

Jean-Luc

Quoted 5 lines

--

Jeff Garzik       | "You see, in this world there's two kinds of
Building 1024     |  people, my friend: Those with loaded guns
MandrakeSoft      |  and those who dig. You dig."  --Blondie

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/