Parallel Port doesn't detect EPP
Hi,
I have just two questions regarding parallel port support with my Via686a chipset:
#1) EPP is no longer listed as supported transfer mode, but it used
to be.
#2) What is that "Can't probe parallel port" message?
Regards,
Udo.
PnPBIOS: Parport found PNPBIOS PNP0401 at io=0378,0778 irq=7 dma=3 0x378: FIFO is 16 bytes0x378: writeIntrThreshold is 80x378: readIntrThreshold is 80x378: PWord is 8 bits0x378: Interrupts are ISA-Pulses0x378: ECP port cfgA=0x10 cfgB=0x000x378: ECP settings irq=<none or set by other means> dma=<none or set by other means>
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
parport0: cpp_daisy: aa5500ff(88)
parport0: assign_addrs: aa5500ff(88)
parport0: Printer, Hewlett-Packard HP LaserJet 6Lparport_pc: Strange, can't probe Via 686A parallel port: io=0x378, irq=7, dma=3
Quoted 2 lines · Udo A. Steinberg
#1) EPP is no longer listed as supported transfer mode, but it used
to be.
<rule_out_the_obvious>
Have you changed your BIOS setting since you last tried it? What does your BIOS say about your parallel port? </rule_out_the_obvious>
Tim.
*/
Hi,
Quoted 5 lines · * On Mon, Sep 03, 2001 at 09:46 PM (+0200), Udo A. Steinberg wrote:
I have just two questions regarding parallel port support with my Via686a chipset:
#1) EPP is no longer listed as supported transfer mode, but it used
to be.
What's your BIOS setting for your parallel port?
I've got quite the same "problem" when setting it to "ECP+PPP". When configuring "EPP" mode it runs well (and my Iomega ZIP drive ("ppa") is able to use 32 bit mode) - I don't need "ECP" mode here.
My motherboard ist an "Epox 8kta+".
Regards,
Steffen
Quoted 7 lines · Tim Waugh
Quoted 2 lines
#1) EPP is no longer listed as supported transfer mode, but it used
to be.<
rule_out_the_obvious>
Have you changed your BIOS setting since you last tried it? What does your BIOS say about your parallel port? </rule_out_the_obvious>
My BIOS setting has always been "ECP+EPP". After Steffen's mail regarding "ECP+EPP" I've changed my parport BIOS setting to "EPP" and using 2.4 I now get:
parport0: PC-style at 0x378, irq 7 [PCSPP,TRISTATE,EPP]
I also tried 2.2. with "ECP+EPP" and it detects both ECP and EPP:
[SPP,ECP,ECPEPP,ECPPS2]
Apparently 2.4. doesn't detect the parport settings the same way 2.2. does.
Regards,
Udo.