MDPPro850 or EST8240
Hi,
Anyone had successfully put ppcboot on the MDPPro850 or EST 8240 board? If so, could you please share some code on that?
I am trying to put ppcboot on MDPPro 850, but it always stop after printing:
DRAM : 0MB
Anybody can help? I am very appreciated.
Sicnerely,
Jin
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 2 lines · In message <[email protected]> you wrote:
Anyone had successfully put ppcboot on the MDPPro850 or EST 8240 board?
Nobody that I know of.
Quoted 3 lines
I am trying to put ppcboot on MDPPro 850, but it always stop after printing:
DRAM : 0MB
Obviously either your RAM initialization and/or your RAM sizing code is broken.
Better help probably on the ppcboot mailing list; you can subscribe at http://lists.sourceforge.net/lists/listinfo/ppcboot-users
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] To get something done, a committee should consist of no more than three men, two of them absent.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/