Skip to contentSkip to conversation

MDPPro850 or EST8240

DISCUSSION Jin Cheng 2 participants 2 messages Apr 15, 2002

lore
Share & tools
lore

Jin Cheng

author
#0 lore raw

Hi,

Anyone had successfully put ppcboot on the MDPPro850 or EST 8240 board? If so, could you please share some code on that?

I am trying to put ppcboot on MDPPro 850, but it always stop after printing:
DRAM : 0MB

Anybody can help? I am very appreciated.

Sicnerely,

Jin

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

Anyone had successfully put ppcboot on the MDPPro850 or EST 8240 board?

Nobody that I know of.

Quoted 3 lines

I am trying to put ppcboot on MDPPro 850, but it always stop after printing:
DRAM : 0MB

Obviously either your RAM initialization and/or your RAM sizing code is broken.

Better help probably on the ppcboot mailing list; you can subscribe at http://lists.sourceforge.net/lists/listinfo/ppcboot-users

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] To get something done, a committee should consist of no more than three men, two of them absent.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/