Skip to contentSkip to conversation

IDE Problems with 2.5.39

DISCUSSION Andrew Walrond 2 participants 3 messages Sep 29, 2002 – Sep 30, 2002

lore
Share & tools
lore
#0 lore raw

Hi,

I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic

Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3

Is this a known problem? Any way around it or patches?

TIA
Andrew

#1 lore raw
Quoted 10 lines · Andrew Walrond

Hi,

I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic

Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3

Is this a known problem? Any way around it or patches?

I used to have this problem with 2.5 too
It went from the IDE controller chipset.

Are you sure that you have only 1 IDE controller chipset ?

I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got exactly your problem). I had to enable specific support for both.

I suppose your root FS is on a specific IDE controller for which the support is not enabled (check the different type in the IDE/ATA kernel config section)

Regards.

#2 lore raw

Nope; This is the latest Asus PR-DLS dual Xeon motherboard with

ServerWorks^® Grand Champion LE North Bridge (CMIC-LE) ServerWorks^® Champion South Bridge (CSB5) ServerWorks^® 64-bit PCI-X Bridge (CIOB-X2)

And the Serverworks IDE driver doesn't see my drive. Works Fine with 2.4.20-pre8

Who should I be talking to?

Quoted 30 lines · JF
Quoted 9 lines · Andrew Walrond

Hi,

I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic

Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3

Is this a known problem? Any way around it or patches?

I used to have this problem with 2.5 too
It went from the IDE controller chipset.

Are you sure that you have only 1 IDE controller chipset ?

I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got exactly your problem). I had to enable specific support for both.

I suppose your root FS is on a specific IDE controller for which the support is not enabled (check the different type in the IDE/ATA kernel config section)

Regards.