IDE Problems with 2.5.39
Hi,
I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic
Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3
Is this a known problem? Any way around it or patches?
TIA
Andrew
Quoted 10 lines · Andrew Walrond
Hi,
I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic
Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3
Is this a known problem? Any way around it or patches?
I used to have this problem with 2.5 too
It went from the IDE controller chipset.
Are you sure that you have only 1 IDE controller chipset ?
I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got exactly your problem). I had to enable specific support for both.
I suppose your root FS is on a specific IDE controller for which the support is not enabled (check the different type in the IDE/ATA kernel config section)
Regards.
Nope; This is the latest Asus PR-DLS dual Xeon motherboard with
ServerWorks^® Grand Champion LE North Bridge (CMIC-LE) ServerWorks^® Champion South Bridge (CSB5) ServerWorks^® 64-bit PCI-X Bridge (CIOB-X2)
And the Serverworks IDE driver doesn't see my drive. Works Fine with 2.4.20-pre8
Who should I be talking to?
Quoted 30 lines · JF
Quoted 9 lines · Andrew Walrond
Hi,
I can't boot with 2.5.39 because the built-in ide driver (ServerWorks CSB5) can't see hda, and VFS says "Cannot open root device "hda3" or 03:03" which results in a kernel panic
Works fine with 2.4.20-pre? with identical kernel setup and kernel parameter root=/dev/hda3
Is this a known problem? Any way around it or patches?
I used to have this problem with 2.5 too
It went from the IDE controller chipset.Are you sure that you have only 1 IDE controller chipset ?
I have both PIIX4 and HPT366. Root FS is on HPT366 controller. Enabling only PIIX4 used to work with 2.4 but doesn't with 2.5 anymore (got exactly your problem). I had to enable specific support for both.
I suppose your root FS is on a specific IDE controller for which the support is not enabled (check the different type in the IDE/ATA kernel config section)
Regards.