Interesting observation of cs46xx bass issues
I was fooling around w/ the mixer with the new cs46xx dsp driver, and I noticed that if I set the volume of one stereo channel (either left or right) to the lowest value in Master, the bass magically comes back! However, this invariably results in only one speaker playing music, but the subwoofer definitly plays bass now. Muting the volume of only one channel in PCM also does the same trick. However, bringing both channels to the same level results in the absence of bass again. Any ideas?
Signature · 11 lines
Weijia Yang School of Electrical and Computer Engineering Georgia Institute of Technology Atlanta, GA ------------------------------------------------------- This sf.net email is sponsored by: Access Your PC Securely with GoToMyPC. Try Free Now https://www.gotomypc.com/s/OSND/DD
Quoted 7 lines · Weijia Yang
I was fooling around w/ the mixer with the new cs46xx dsp driver, and I noticed that if I set the volume of one stereo channel (either left or right) to the lowest value in Master, the bass magically comes back! However, this invariably results in only one speaker playing music, but the subwoofer definitly plays bass now. Muting the volume of only one channel in PCM also does the same trick. However, bringing both channels to the same level results in the absence of bass again. Any ideas?
This sounds like the effect achieved when one channel is out-of-phase in an analog system.
Regards,
Mark
-------------------------------------------------------
This sf.net email is sponsored by:
Access Your PC Securely with GoToMyPC. Try Free Now
https://www.gotomypc.com/s/OSND/DD