Trouble w/ e1000 v4.4.19 for Intel gigabit 82545EM on-board chip.
Under SuSE-8.1-CDROM supplied 2.4.19-UP with e1000 v4.3.15 module, this ethernet worked on a E7505 based Supermicro X5DA8 Dual Xeon motherboard with the Intel 82545EM chip on board with no special kernel option inserted. The RJ45 is hooked to 100Mb/s speed CISCO switching hub.
Now, e1000 v4.4.19 custom-built 2.4.21-pre4ac4 with SMP enabled does not work. e1000 is detected. It appeared properly in ifconfig with its own HWaddr. But it does not work.
For the moment, netgear 100Mb/s card is inserted and enabled by module. And this one is working right now.
Does anyone have a similar trouble with e1000?
Thanks a lot.
Regards to all the Kernel developers.
G. Hugh Song
Quoted 6 lines · ghugh Song
Under SuSE-8.1-CDROM supplied 2.4.19-UP with e1000 v4.3.15 module, this ethernet worked on a E7505 based Supermicro X5DA8 Dual Xeon motherboard with the Intel 82545EM chip on board with no special kernel option
inserted. The RJ45 is hooked to 100Mb/s speed CISCO switching hub.Now, e1000 v4.4.19 custom-built 2.4.21-pre4ac4 with SMP enabled does not work. e1000 is detected. It appeared properly in ifconfig with its own HWaddr. But it does not work.
Does stock 2.4.20 work?
Does 2.4.20 + 2.4.21-pre4 pre-patch work?