Skip to contentSkip to conversation

Trouble w/ e1000 v4.4.19 for Intel gigabit 82545EM on-board chip.

DISCUSSION ghugh Song 2 participants 2 messages Feb 17, 2003

lore
Share & tools
lore

ghugh Song

author
#0 lore raw

Under SuSE-8.1-CDROM supplied 2.4.19-UP with e1000 v4.3.15 module, this ethernet worked on a E7505 based Supermicro X5DA8 Dual Xeon motherboard with the Intel 82545EM chip on board with no special kernel option inserted. The RJ45 is hooked to 100Mb/s speed CISCO switching hub.

Now, e1000 v4.4.19 custom-built 2.4.21-pre4ac4 with SMP enabled does not work. e1000 is detected. It appeared properly in ifconfig with its own HWaddr. But it does not work.

For the moment, netgear 100Mb/s card is inserted and enabled by module. And this one is working right now.

Does anyone have a similar trouble with e1000?

Thanks a lot.

Regards to all the Kernel developers.

G. Hugh Song

#1 lore raw
Quoted 6 lines · ghugh Song

Under SuSE-8.1-CDROM supplied 2.4.19-UP with e1000 v4.3.15 module, this ethernet worked on a E7505 based Supermicro X5DA8 Dual Xeon motherboard with the Intel 82545EM chip on board with no special kernel option
inserted. The RJ45 is hooked to 100Mb/s speed CISCO switching hub.

Now, e1000 v4.4.19 custom-built 2.4.21-pre4ac4 with SMP enabled does not work. e1000 is detected. It appeared properly in ifconfig with its own HWaddr. But it does not work.

Does stock 2.4.20 work?
Does 2.4.20 + 2.4.21-pre4 pre-patch work?