About mkinitrd ...
Hi,
I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am using the same config file as Mark MacMillan(who has compiled SELinux on VMware) has sent me . I am getting the following error :
"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"
I have installed the 'mkinitrd-3.5.8-2.src.rpm' from ftp://rawhide.redhat.com/pub/redhat/linux/rawhide/SRPMS/SRPMS/
Also I have installed the module-init-tools-0.9.13-pre.tar.gz and oprofile-0.5.4.tar.gz .I have all (except nfs-tools) as required for SELinux (Documentation/Changes)
any clues why this is happening ? Do I need anything else ? Thanks,
-Ripin.
Quoted 1 line · Ripin Natani
I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am
...
Quoted 1 line
"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"
Last night, I compiled new SELinux on VMware and got same message. I change the BusLogic SCSI comfiguration to 'module'.
CONFIG_SCSI_BUSLOGIC=m
It works fine.
Thanks.
Signature · 7 lines
UENO Shuichi -- This message was distributed to subscribers of the selinux mailing list. If you no longer wish to subscribe, send mail to [email protected] with the words "unsubscribe selinux" without quotes as the message.
Quoted 9 lines · Ripin Natani
Hi,
I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am using the same config file as Mark MacMillan(who has compiled SELinux on VMware) has sent me .
I am getting the following error :"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"
Quoted 7 lines
I have installed the 'mkinitrd-3.5.8-2.src.rpm' from ftp://rawhide.redhat.com/pub/redhat/linux/rawhide/SRPMS/SRPMS/ Also I have installed the module-init-tools-0.9.13-pre.tar.gz and oprofile-0.5.4.tar.gz .I have all (except nfs-tools) as required for SELinux (
Documentation/Changes)any clues why this is happening ? Do I need anything else ?
I don't know about the BusLogic error, but you do need to patch your mkinitrd script as described in the selinux-doc README so that it will set up the initrd to perform an initial policy load.
Signature · 8 lines
Stephen Smalley <[email protected]> National Security Agency -- This message was distributed to subscribers of the selinux mailing list. If you no longer wish to subscribe, send mail to [email protected] with the words "unsubscribe selinux" without quotes as the message.