Skip to contentSkip to conversation

About mkinitrd ...

DISCUSSION Ripin Natani 3 participants 3 messages Aug 27, 2003 – Aug 28, 2003 SELinux security module

lore
Share & tools
lore
#0 lore raw

Hi,
I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am using the same config file as Mark MacMillan(who has compiled SELinux on VMware) has sent me . I am getting the following error :

"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"

I have installed the 'mkinitrd-3.5.8-2.src.rpm' from ftp://rawhide.redhat.com/pub/redhat/linux/rawhide/SRPMS/SRPMS/
Also I have installed the module-init-tools-0.9.13-pre.tar.gz and oprofile-0.5.4.tar.gz .I have all (except nfs-tools) as required for SELinux (Documentation/Changes)

any clues why this is happening ? Do I need anything else ? Thanks,
-Ripin.

#1 lore raw
Quoted 1 line · Ripin Natani

I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am

...

Quoted 1 line

"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"

Last night, I compiled new SELinux on VMware and got same message. I change the BusLogic SCSI comfiguration to 'module'.

CONFIG_SCSI_BUSLOGIC=m

It works fine.

Thanks.

Signature · 7 lines
UENO Shuichi


--
This message was distributed to subscribers of the selinux mailing list.
If you no longer wish to subscribe, send mail to [email protected] with
the words "unsubscribe selinux" without quotes as the message.
#2 lore raw
In reply to Ripin Natani
Quoted 9 lines · Ripin Natani

Hi,
I am compiling SElinux on VMWare (VM : rh 9.0 , Host rh 9.0). I am using the same config file as Mark MacMillan(who has compiled SELinux on VMware) has sent me .
I am getting the following error :

"No module BusLogic found for kernel mykernel, aborting mkinitrd failed"

Quoted 7 lines

I have installed the 'mkinitrd-3.5.8-2.src.rpm' from ftp://rawhide.redhat.com/pub/redhat/linux/rawhide/SRPMS/SRPMS/ Also I have installed the module-init-tools-0.9.13-pre.tar.gz and oprofile-0.5.4.tar.gz .I have all (except nfs-tools) as required for SELinux (Documentation/Changes)

any clues why this is happening ? Do I need anything else ?

I don't know about the BusLogic error, but you do need to patch your mkinitrd script as described in the selinux-doc README so that it will set up the initrd to perform an initial policy load.

Signature · 8 lines
Stephen Smalley <[email protected]>
National Security Agency


--
This message was distributed to subscribers of the selinux mailing list.
If you no longer wish to subscribe, send mail to [email protected] with
the words "unsubscribe selinux" without quotes as the message.