Skip to contentSkip to conversation

boot linux_ppc_2_4

DISCUSSION Ronen Shitrit 2 participants 2 messages Nov 5, 2003

lore
Share & tools
lore
#0 lore raw

Hi

I have a U-Boot which is working just fine,
and I'm trying to boot a kernel(ver 2.4) image with it , after I load the uImage to the DRAM by using the tftp as it is described in the README file, I'm doing bootm to the uImage location,
I see that the code is getting to the kernel code , but there it get lost after we disable the MMU in head.S.

(I know that the kernel version I have should be stable on my board cause with the DINK monitor
I can load it just fine.)

Are there any special changes I should make to the Kernel in order for it to be able to boot from the U-Boot??
If so, where can I find a good reference for it??

Thanks a lot

--
Ronen Shitrit

M.S.I.L
D.N. Misgav 20184

Tel:   +972-4-9951000
Fax:   +972-4-9951001
Email: mailto: [email protected]

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

#1 lore raw
Quoted 3 lines · In message <[email protected]> you wrote:

I have a U-Boot which is working just fine,
and I'm trying to boot a kernel(ver 2.4) image with it ,

Please do not post the same message to several mailing lists.

Answered in u-boot-users.

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] 1 1 was a race-horse, 2 2 was 1 2. When 1 1 1 1 race, 2 2 1 1 2.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/