Skip to contentSkip to conversation

2.6.6-mm-rc3-mm2 USB 2.0 after suspend issue

DISCUSSION David Brownell 2 participants 2 messages May 13, 2004

lore
Share & tools
lore
#0 lore raw

You said 2.6.6-rc3-mm2 gives you these strange messages, but how does 2.6.6-mm2 behave?

Quoted 2 lines

ehci_hcd 0000:00:1d.7: suspend D0 --> D3
ehci_hcd 0000:00:1d.7: No PM capability

2.6.6-mm2 won't give that message pair. The EHCI suspend/resume should work better though.

Quoted 6 lines

uhci_hcd 0000:00:1d.2: suspend D4 --> D3
uhci_hcd 0000:00:1d.2: suspend_hc
uhci_hcd 0000:00:1d.1: suspend D4 --> D3
uhci_hcd 0000:00:1d.1: suspend_hc
uhci_hcd 0000:00:1d.0: suspend D4 --> D3
uhci_hcd 0000:00:1d.0: suspend_hc

Those messages are a bit strange. If it still misbehaves in 2.6.6-mm2, please send "lspci -vv" info for these USB controllers. (Preferably to linux-usb-devel, where it's easier to see.)

Quoted 3 lines

...
ehci_hcd 0000:00:1d.7: resume from state D0 ehci_hcd 0000:00:1d.7: can't resume, not suspended!

Again, 2.6.6-mm2 shouldn't do that.

- Dave

#1 lore raw

2.6.6-mm2 does indeed fix the EHCI problem and those messages; I guess I didn't read the patches closely enough. Instead, though, I have a new problem related to suspend/resume in 2.6.6-mm2 where an attached USB mouse will stop responding after a resume, but unplugging & plugging the device back in will work fine. I was going to send a message off to usb-devel about it, but Thunderbird ended up losing my entire e-mail and I was too lazy to re-type it.

Quoted 15 lines · David Brownell

Those messages are a bit strange. If it still misbehaves in 2.6.6-mm2, please send "lspci -vv" info for these USB controllers. (Preferably to linux-usb-devel, where it's easier to see.)

Quoted 3 lines

...
ehci_hcd 0000:00:1d.7: resume from state D0 ehci_hcd 0000:00:1d.7: can't resume, not suspended!

Again, 2.6.6-mm2 shouldn't do that.

- Dave