2.6.6-mm-rc3-mm2 USB 2.0 after suspend issue
You said 2.6.6-rc3-mm2 gives you these strange messages, but how does 2.6.6-mm2 behave?
Quoted 2 lines
ehci_hcd0000:00:1d.7: suspend D0 --> D3ehci_hcd0000:00:1d.7: No PM capability
2.6.6-mm2 won't give that message pair. The EHCI suspend/resume should work better though.
Quoted 6 lines
uhci_hcd0000:00:1d.2: suspend D4 --> D3uhci_hcd0000:00:1d.2:suspend_hcuhci_hcd0000:00:1d.1: suspend D4 --> D3uhci_hcd0000:00:1d.1:suspend_hcuhci_hcd0000:00:1d.0: suspend D4 --> D3uhci_hcd0000:00:1d.0:suspend_hc
Those messages are a bit strange. If it still misbehaves in 2.6.6-mm2, please send "lspci -vv" info for these USB controllers. (Preferably to linux-usb-devel, where it's easier to see.)
Quoted 3 lines
...
ehci_hcd0000:00:1d.7: resume from state D0ehci_hcd0000:00:1d.7: can't resume, not suspended!
Again, 2.6.6-mm2 shouldn't do that.
- Dave
2.6.6-mm2 does indeed fix the EHCI problem and those messages; I guess I didn't read the patches closely enough. Instead, though, I have a new problem related to suspend/resume in 2.6.6-mm2 where an attached USB mouse will stop responding after a resume, but unplugging & plugging the device back in will work fine. I was going to send a message off to usb-devel about it, but Thunderbird ended up losing my entire e-mail and I was too lazy to re-type it.
Quoted 15 lines · David Brownell
Those messages are a bit strange. If it still misbehaves in 2.6.6-mm2, please send "lspci -vv" info for these USB controllers. (Preferably to linux-usb-devel, where it's easier to see.)
Quoted 3 lines
...
ehci_hcd0000:00:1d.7: resume from state D0ehci_hcd0000:00:1d.7: can't resume, not suspended!Again, 2.6.6-mm2 shouldn't do that.
- Dave