U-Boot version for a new port
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi,
Quoted 4 lines
From: "Roman Mashak" <[email protected]>
Subject: [U-Boot] U-Boot version for a new port
I'm planning to make a port on a ARM926EJ-S based board. What is the recommended way: take release or GIT version as a base ?
Depends on what processor you are using, atmel at91sam9 series or omap or ti davinci
If s, then check if your board/processor configs match with any of these.
Try to port their configuration & files to your board.
Look at arm versatile board, ti davinci boards for reference.
Hope this helps
Regards
Gururaja
Hi,
2008/9/2 Gururaja Hebbar K R <[email protected]>:
Quoted 2 lines
Depends on what processor you are using, atmel at91sam9 series or omap or ti davinci
It's LG's system-on-chip, consisting of main CPU (ARM926EJ-S based), running at 216MHz, mpeg2/mpeg4/audio decoding engines, LCD interface, UART. On-chip ROM available serves for preliminary bootloader, which copies NAND flash content in to SDRAM.
Quoted 6 lines
If s, then check if your board/processor configs match with any of these.
Try to port their configuration & files to your board.
Look at arm versatile board, ti davinci boards for reference.
I was considering this, but thought there would probably be something more specific. Anyway, I need to investigate H/W more thoroughly.
Signature · 1 line
Roman Mashak