Skip to contentSkip to conversation

U-Boot version for a new port

U-Boot Gururaja Hebbar K R 2 participants 2 messages Sep 3, 2008 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hi,

Quoted 4 lines

From: "Roman Mashak" <[email protected]>
Subject: [U-Boot] U-Boot version for a new port
I'm planning to make a port on a ARM926EJ-S based board. What is the recommended way: take release or GIT version as a base ?

Depends on what processor you are using, atmel at91sam9 series or omap or ti davinci

If s, then check if your board/processor configs match with any of these.

Try to port their configuration & files to your board.

Look at arm versatile board, ti davinci boards for reference.

Hope this helps

Regards
Gururaja

#2 lore raw

Hi,

2008/9/2 Gururaja Hebbar K R <[email protected]>:

Quoted 2 lines

Depends on what processor you are using, atmel at91sam9 series or omap or ti davinci

It's LG's system-on-chip, consisting of main CPU (ARM926EJ-S based), running at 216MHz, mpeg2/mpeg4/audio decoding engines, LCD interface, UART. On-chip ROM available serves for preliminary bootloader, which copies NAND flash content in to SDRAM.

Quoted 6 lines

If s, then check if your board/processor configs match with any of these.

Try to port their configuration & files to your board.

Look at arm versatile board, ti davinci boards for reference.

I was considering this, but thought there would probably be something more specific. Anyway, I need to investigate H/W more thoroughly.

Signature · 1 line
Roman Mashak