alim7101_wdt problem on 2.6.10
Hi,
I have a Vaio C1MZX and in the lspci I saw this line:
0000:00:11.0 Non-VGA unclassified device: ALi Corporation M7101 Power Management Controller [PMU]
So, I assumed it was a watchdog and I compiled with the option:CONFIG_ALIM7101_WDT=m
But, when I do: modprobe alim7101_wdt
I get the following error message:
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: Steve Hill <[email protected]>. Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does
not have the correct revision number (???1001?) - WDT not set
What did I do wrong ?
If some patches need to be tried out, I volunteer. :)
Thanks in advance for you reply
Signature · 6 lines
Emmanuel Fleury Computer Science Department, | Office: B1-201 Aalborg University, | Phone: +45 96 35 72 23 Fredriks Bajersvej 7E, | Fax: +45 98 15 98 89 9220 Aalborg East, Denmark | Email: [email protected]
Quoted 5 lines · Emmanuel Fleury
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge doesnot have the correct revision number (???1001?) - WDT not set
What did I do wrong ?
You used the wrong South Bridge revision. Seriously, older revisions of M7101 did not have a WDT. You seem to have an older revision. Sorry.
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Quoted 6 lines · Tim Hockin
Quoted 4 lines · Emmanuel Fleury
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge doesnot have the correct revision number (???1001?) - WDT not set
Quoted 6 lines
Quoted 1 line
What did I do wrong ?
You used the wrong South Bridge revision. Seriously, older revisions of M7101 did not have a WDT. You seem to have an older revision. Sorry.
FWIW, some of the old cobalt boxes had the old south bridge revision with a WDT. It managed to do resets/wdt off gpio pin 5 though, and there is a patch in Alan's 2.6.10-ac tree that handles it.
Whether or not it will work with your vaio? Probably not, though I guess it wouldn't hurt to try (modprobe alim7101_wdt use_gpio=1).
- --
Mike Waychison
Sun Microsystems, Inc.
1 (650) 352-5299 voice
1 (416) 202-8336 voice
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NOTICE: The opinions expressed in this email are held by me, and may not represent the views of Sun Microsystems, Inc.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org
iD8DBQFB/n8/dQs4kOxk3/MRAg/HAJ4x+SdKXwNDsKrtBMS9xLYcYLYVigCdHBTk CWSOMh5FZPmfrky713Avd4g=
=DMs9
-----END PGP SIGNATURE-----
Quoted 3 lines · Mike Waychison
FWIW, some of the old cobalt boxes had the old south bridge revision with a WDT. It managed to do resets/wdt off gpio pin 5 though, and there is a patch in Alan's 2.6.10-ac tree that handles it.
The old Cobalts also had a PIC attached to act as a WDT. :)