Skip to contentSkip to conversation

alim7101_wdt problem on 2.6.10

Watchdog Emmanuel Fleury 3 participants 4 messages Jan 31, 2005

lore
Share & tools
lore
#0 lore raw

Hi,

I have a Vaio C1MZX and in the lspci I saw this line:
0000:00:11.0 Non-VGA unclassified device: ALi Corporation M7101 Power Management Controller [PMU]

So, I assumed it was a watchdog and I compiled with the option:
CONFIG_ALIM7101_WDT=m

But, when I do: modprobe alim7101_wdt

I get the following error message:

Jan 30 00:58:21 hermes vmunix: alim7101_wdt: Steve Hill
<[email protected]>.
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does

not have the correct revision number (???1001?) - WDT not set

What did I do wrong ?

If some patches need to be tried out, I volunteer. :)

Thanks in advance for you reply

Signature · 6 lines
Emmanuel Fleury

Computer Science Department, |  Office: B1-201
Aalborg University,          |  Phone:  +45 96 35 72 23
Fredriks Bajersvej 7E,       |  Fax:    +45 98 15 98 89
9220 Aalborg East, Denmark   |  Email:  [email protected]
#1 lore raw
Quoted 5 lines · Emmanuel Fleury
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does

not have the correct revision number (???1001?) - WDT not set

What did I do wrong ?

You used the wrong South Bridge revision. Seriously, older revisions of M7101 did not have a WDT. You seem to have an older revision. Sorry.

#2 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Quoted 6 lines · Tim Hockin
Quoted 4 lines · Emmanuel Fleury
Jan 30 00:58:21 hermes vmunix: alim7101_wdt: ALi 1543 South-Bridge does

not have the correct revision number (???1001?) - WDT not set

Quoted 6 lines
Quoted 1 line

What did I do wrong ?

You used the wrong South Bridge revision. Seriously, older revisions of M7101 did not have a WDT. You seem to have an older revision. Sorry.

FWIW, some of the old cobalt boxes had the old south bridge revision with a WDT. It managed to do resets/wdt off gpio pin 5 though, and there is a patch in Alan's 2.6.10-ac tree that handles it.

Whether or not it will work with your vaio? Probably not, though I guess it wouldn't hurt to try (modprobe alim7101_wdt use_gpio=1).

- --
Mike Waychison
Sun Microsystems, Inc.
1 (650) 352-5299 voice
1 (416) 202-8336 voice

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NOTICE: The opinions expressed in this email are held by me, and may not represent the views of Sun Microsystems, Inc.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFB/n8/dQs4kOxk3/MRAg/HAJ4x+SdKXwNDsKrtBMS9xLYcYLYVigCdHBTk CWSOMh5FZPmfrky713Avd4g=
=DMs9
-----END PGP SIGNATURE-----

#3 lore raw
Quoted 3 lines · Mike Waychison

FWIW, some of the old cobalt boxes had the old south bridge revision with a WDT. It managed to do resets/wdt off gpio pin 5 though, and there is a patch in Alan's 2.6.10-ac tree that handles it.

The old Cobalts also had a PIC attached to act as a WDT. :)