MPC5200 + multi serial chips (16554)
Hi
I have to develop an embedded system with a MPC5200 and eight 16554 (32 serial ports). I'll use a chip seletec to manage the eight multi serial chips
with an external CPLD.
May I manage the serial ports with setserial linux program or I have to develop a new device driver?
Thank you in advance
Best Regards
Andrea Sorio
Signature · 5 lines
Ing. Andrea Sorio Hardware & Software Engineer Freelance email: a.sorio at cocay.it Phone: 348 8703449
Quoted 3 lines · In message <[email protected]> you wrote:
I have to develop an embedded system with a MPC5200 and eight 16554 (32 serial ports). I'll use a chip seletec to manage the
Do you need to support all these 8 UART ports in _U-Boot_ ???
Quoted 2 lines
May I manage the serial ports with setserial linux program or I have to develop a new device driver?
seterial is an application program that requires an OS to run. It won't help you for U-Boot. [Yes, this is the U-Boot mailing list, and we're discussing U-Boot issues here.]
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de "Beware of programmers carrying screwdrivers." - Chip Salzenberg
Dear Wolfgang
Thank you for your replay.
Quoted 8 lines
Quoted 4 lines
I have to develop an embedded system with a MPC5200 and eight 16554 (32 serial ports). I'll use a chip seletec to manage the
Do you need to support all these 8 UART ports in _U-Boot_ ???
No, I don't need them in U-Boot.
Quoted 10 lines
Quoted 4 lines
May I manage the serial ports with setserial linux program or I have to develop a new device driver?
seterial is an application program that requires an OS to run. It won't help you for U-Boot. [Yes, this is the U-Boot mailing list, and we're discussing U-Boot issues here.]
Yes, I know.
I would like to install u-boot and linux embedded in this board. I hope that setserial could set up the linux serial device driver to manage the 32 serial
ports without any changes on serial driver. (I apologize for my english)
Thank you
Best regards
Andrea Sorio
Signature · 5 lines
Ing. Andrea Sorio Hardware & Software Engineer Freelance email: a.sorio at cocay.it Phone: 348 8703449
Dear Andrea,
Quoted 2 lines · in message <[email protected]> you wrote:
No, I don't need them in U-Boot.
Then this is actually off topic here.
Quoted 4 lines
I would like to install u-boot and linux embedded in this board. I hope that setserial could set up the linux serial device driver to manage the 32 serial
ports without any changes on serial driver. (I apologize for my english)
Your English is adequate.
Don;t expect setserial to be of any help on a non-x86 system. You will have to tweak at least the mapping for the serial driver in Linux. But as I said, this is off topic here.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
What about WRITING it first and rationalizing it afterwords? :-)
- Larry Wall in <[email protected]>