Upload from U-Boot to serial-client?
Hi there,
I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?
Best regards,
Martin
Dear Martin,
Quoted 4 lines · in message <[email protected]> you wrote:
I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?
Sure. Enable CFG_CMD_SAVES in your command definitions and use the "saves" command (save S-Record file over serial line).
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Life would be so much easier if everyone read the manual.
Hi Wolfgang,
Quoted 5 lines
Quoted 3 lines
I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?
Sure. Enable
CFG_CMD_SAVESin your command definitions and use the "saves" command (save S-Record file over serial line).
Fantastic!
Thanks,
Martin