Skip to contentSkip to conversation

Upload from U-Boot to serial-client?

U-Boot-Users Martin Egholm Nielsen 2 participants 3 messages Feb 11, 2005

lore
Share & tools
lore
#0 lore raw

Hi there,

I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?

Best regards,
Martin

#1 lore raw

Dear Martin,

Quoted 4 lines · in message <[email protected]> you wrote:

I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?

Sure. Enable CFG_CMD_SAVES in your command definitions and use the "saves" command (save S-Record file over serial line).

Best regards,

Wolfgang Denk

Signature · 3 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Life would be so much easier if everyone read the manual.
#2 lore raw

Hi Wolfgang,

Quoted 5 lines
Quoted 3 lines

I know this was up a couple of years ago :-) (PPCBoot related), but is there a way (besides dumping with "md") to upload data to a client using the serial-/ethernet-connection?

Sure. Enable CFG_CMD_SAVES in your command definitions and use the "saves" command (save S-Record file over serial line).

Fantastic!

Thanks,
Martin