Skip to contentSkip to conversation

Modem connection problems with Kernel 2.6.11-bk1 + bk2

DISCUSSION Michael Berger 1 participant 1 message Mar 8, 2005

lore
Share & tools
lore
#0 lore raw
Quoted 9 lines · Michael Berger

Dear LKML

Since Kernel Release 2.6.11-bk1 + bk2 it is not possible to connect in >to the Internet via a modem connection.

Following message is in my System Log:

Quoted 1 line
Mar  6 19:02:08 Odin wvdial[3079]: stdin not read/write and $MODEM >not set Mar  6 19:02:08 Odin pppd[3032]: Connect script failed
Quoted 6 lines

Kernel 2.6.11 works without any problems. Attached is my config file.

Best regards,

-- Michael

-- snip->

Dear LKML

Reverting attached patch fixes my serial modem connection problem.

Best regards,

-- Michael

drivers/serial/8250.c +35 -0
diff -Nru a/drivers/serial/8250.c b/drivers/serial/8250.c
@@ -642,6 +642,7 @@
 static void autoconfig_16550a(struct uart_8250_port *up)
 {
 	unsigned char status1, status2;
+	unsigned int iersave;
 
 	up->port.type = PORT_16550A;
 	up->capabilities |= UART_CAP_FIFO;
@@ -736,6 +737,40 @@
 		up->capabilities |= UART_CAP_AFE | UART_CAP_SLEEP;
 		return;
 	}
+
+	/*
+	 * Try writing and reading the UART_IER_UUE bit (b6).
+	 * If it works, this is probably one of the Xscale platform's
+	 * internal UARTs.
+	 * We're going to explicitly set the UUE bit to 0 before
+	 * trying to write and read a 1 just to make sure it's not
+	 * already a 1 and maybe locked there before we even start start.
+	 */
+	iersave = serial_in(up, UART_IER);
+	serial_outp(up, UART_IER, iersave & ~UART_IER_UUE);
+	if (!(serial_in(up, UART_IER) & UART_IER_UUE)) {
+		/*
+		 * OK it's in a known zero state, try writing and reading
+		 * without disturbing the current state of the other bits.
+		 */
+		serial_outp(up, UART_IER, iersave | UART_IER_UUE);
+		if (serial_in(up, UART_IER) & UART_IER_UUE) {
+			/*
+			 * It's an Xscale.
+			 * We'll leave the UART_IER_UUE bit set to 1 (enabled).
+			 */
+			DEBUG_AUTOCONF("Xscale ");
+			up->port.type = PORT_XSCALE;
+			return;
+		}
+	} else {
+		/*
+		 * If we got here we couldn't force the IER_UUE bit to 0.
+		 * Log it and continue.
+		 */
+		DEBUG_AUTOCONF("Couldn't force IER_UUE to 0 ");
+	}
+	serial_outp(up, UART_IER, iersave);
 }
 
 /*