Modem connection problems with Kernel 2.6.11-bk1 + bk2
Quoted 9 lines · Michael Berger
Dear LKML
Since Kernel Release 2.6.11-bk1 + bk2 it is not possible to connect in >to the Internet via a modem connection.
Following message is in my System Log:
Quoted 1 line
Mar 6 19:02:08 Odin wvdial[3079]: stdin not read/write and $MODEM >not set Mar 6 19:02:08 Odin pppd[3032]: Connect script failed
Quoted 6 lines
Kernel 2.6.11 works without any problems. Attached is my config file.
Best regards,
-- Michael
-- snip->
Dear LKML
Reverting attached patch fixes my serial modem connection problem.
Best regards,
-- Michael
drivers/serial/8250.c +35 -0
@@ -642,6 +642,7 @@static void autoconfig_16550a (struct uart_8250_port *up) {unsigned char status1, status2; +unsigned int iersave; up->port.type =PORT_16550A ; up->capabilities |=UART_CAP_FIFO ;
@@ -736,6 +737,40 @@ up->capabilities |=UART_CAP_AFE |UART_CAP_SLEEP ;return ; } + +/* +* Try writing and reading the UART_IER_UUE bit (b6). +* If it works, this is probably one of the Xscale platform's +* internal UARTs. +* We're going to explicitly set the UUE bit to 0 before +* trying to write and read a 1 just to make sure it's not +* already a 1 and maybe locked there before we even start start. +*/ + iersave =serial_in (up,UART_IER ); +serial_outp (up,UART_IER , iersave & ~UART_IER_UUE ); +if (!(serial_in (up,UART_IER ) &UART_IER_UUE )) { +/* +* OK it's in a known zero state, try writing and reading +* without disturbing the current state of the other bits. +*/ +serial_outp (up,UART_IER , iersave |UART_IER_UUE ); +if (serial_in (up,UART_IER ) &UART_IER_UUE ) { +/* +* It's an Xscale. +* We'll leave the UART_IER_UUE bit set to 1 (enabled). +*/ +DEBUG_AUTOCONF ("Xscale " ); + up->port.type =PORT_XSCALE ; +return ; + } + }else { +/* +* If we got here we couldn't force the IER_UUE bit to 0. +* Log it and continue. +*/ +DEBUG_AUTOCONF ("Couldn't force IER_UUE to 0 " ); + } +serial_outp (up,UART_IER , iersave); }/*