Skip to contentSkip to conversation

Strange behaviour with SATA disks. Light always ON

DISCUSSION Robert Hancock 2 participants 2 messages Sep 26, 2005 – Sep 27, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 7 lines · Paulo da Silva

Hi!
I don't know if this is the right place to ask
about this, or even if this is a problem at all.

Anyway I didn't find relevant information on
this ...

Quoted 6 lines

I have just bought a new PC with two SATA drives. I had no problems to have them working, apparently fine except for one thing:
After reading the kernel, the driver access light (led?) is always on!
Is this normal? Why?

I don't know if this is considered "normal" but I know that the Silicon Image chips do have a strange way of handling the access light - it has to be specifically turned on and off by a GPIO pin in the driver, the chip doesn't seem to handle it itself..

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/
#2 lore raw
Quoted 17 lines · Robert Hancock
Quoted 7 lines · Paulo da Silva

Hi!
I don't know if this is the right place to ask
about this, or even if this is a problem at all.

Anyway I didn't find relevant information on
this ...

Quoted 6 lines

I have just bought a new PC with two SATA drives. I had no problems to have them working, apparently fine except for one thing:
After reading the kernel, the driver access light (led?) is always on!
Is this normal? Why?

Quoted 4 lines

I don't know if this is considered "normal" but I know that the Silicon Image chips do have a strange way of handling the access light
- it has to be specifically turned on and off by a GPIO pin in the
driver, the chip doesn't seem to handle it itself..

Is there any intention to correct this?
Should I file a bug?
I think this should be trivial for those
who know the driver ...

BTW, the kernel configuration has a specific "option" for Silicon Image SATA, but if I choose it without "ahci" the system does not boot! Why?

Thanks