Strange behaviour with SATA disks. Light always ON
Quoted 7 lines · Paulo da Silva
Hi!
I don't know if this is the right place to ask
about this, or even if this is a problem at all.Anyway I didn't find relevant information on
this ...
Quoted 6 lines
I have just bought a new PC with two SATA drives. I had no problems to have them working, apparently fine except for one thing:
After reading the kernel, the driver access light (led?) is always on!
Is this normal? Why?
I don't know if this is considered "normal" but I know that the Silicon Image chips do have a strange way of handling the access light - it has to be specifically turned on and off by a GPIO pin in the driver, the chip doesn't seem to handle it itself..
Signature · 3 lines
Robert Hancock Saskatoon, SK, Canada To email, remove "nospam" from [email protected] Home Page: http://www.roberthancock.com/
Quoted 17 lines · Robert Hancock
Quoted 7 lines · Paulo da Silva
Hi!
I don't know if this is the right place to ask
about this, or even if this is a problem at all.Anyway I didn't find relevant information on
this ...Quoted 6 lines
I have just bought a new PC with two SATA drives. I had no problems to have them working, apparently fine except for one thing:
After reading the kernel, the driver access light (led?) is always on!
Is this normal? Why?
Quoted 4 lines
I don't know if this is considered "normal" but I know that the Silicon Image chips do have a strange way of handling the access light
- it has to be specifically turned on and off by a GPIO pin in the
driver, the chip doesn't seem to handle it itself..
Is there any intention to correct this?
Should I file a bug?
I think this should be trivial for those
who know the driver ...
BTW, the kernel configuration has a specific "option" for Silicon Image SATA, but if I choose it without "ahci" the system does not boot! Why?
Thanks