io apic and shared irq questions
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 11 lines · s.a.
Hi,
Regarding an embedded realtime system, I have got a communication board on pci bus .
I would like it's interrupt not being shared (with usb) , because the component receives an it every 100us and is realtime determinist. I looked at how was routed IRQ's with the io apic , although it is able to use 24 irq's, linux always share my PCI boards IRQ with another component and do not use all the 24 irq's range capability of ioapic.
Quoted 6 lines
Do you think it is possible to program the ioapic in order to have a better irq mapping and avoid this problem and use all the range of availbale vectors ?
Best Regards
Steph
This may depend on the hardware, but as far as I know, usually the IOAPIC interrupt mapping is the same as the physical wiring of the interrupt lines on the board. If the devices use the same physical interrupt line, there is no way to separate them.
Signature · 3 lines
Robert Hancock Saskatoon, SK, Canada To email, remove "nospam" from [email protected] Home Page: http://www.roberthancock.com/