Skip to contentSkip to conversation

io apic and shared irq questions

DISCUSSION Robert Hancock 1 participant 1 message Jun 1, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 11 lines · s.a.

Hi,

Regarding an embedded realtime system, I have got a communication board on pci bus .

I would like it's interrupt not being shared (with usb) , because the component receives an it every 100us and is realtime determinist. I looked at how was routed IRQ's with the io apic , although it is able to use 24 irq's, linux always share my PCI boards IRQ with another component and do not use all the 24 irq's range capability of ioapic.

Quoted 6 lines

Do you think it is possible to program the ioapic in order to have a better irq mapping and avoid this problem and use all the range of availbale vectors ?

Best Regards
Steph

This may depend on the hardware, but as far as I know, usually the IOAPIC interrupt mapping is the same as the physical wiring of the interrupt lines on the board. If the devices use the same physical interrupt line, there is no way to separate them.

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/