Skip to contentSkip to conversation

Failed with error -12

ahci Renato S. Yamane 2 participants 2 messages Nov 21, 2006

lore
Share & tools
lore
#0 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I receive this error message on boot with Kernel 2.6.18.3

relevant (I think) dmesg output:
=======
ahci 0000:00:1f.2: version 2.0
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
ACPI: PCI Interrupt 0000:00:1f.2[B] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
ahci: probe of 0000:00:1f.2 failed with error -12 ata_piix 0000:00:1f.2: version 2.00
ata_piix 0000:00:1f.2: MAP [ P0 P2 IDE IDE ]
ACPI: PCI Interrupt 0000:00:1f.2[B] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:00:1f.2 to 64
ata1: SATA max UDMA/133 cmd 0x1F0 ctl 0x3F6 bmdma 0x1100 irq 14 scsi0 : ata_piix
========

# hwinfo --disk
23: IDE 00.0: 10600 Disk
  [Created at block.191]
  UDI: /org/freedesktop/Hal/devices/storage_serial_75QW2718S
  Unique ID: mE25.WkVGlyavV53
  Parent ID: w7Y8.owfwZLxeTg6
  SysFS ID: /block/sda
  SysFS BusID: 0:0:0:0
  SysFS Device Link:
/devices/pci0000:00/0000:00:1f.2/host0/target0:0:0/0:0:0:0
  Hardware Class: disk
  Model: "TOSHIBA MK1032GA"
  Vendor: "TOSHIBA"
  Device: "MK1032GA"
  Revision: "AB21"
  Serial ID: "75QW2718S"
  Driver: "ata_piix", "sd"
  Device File: /dev/sda
  Device Files: /dev/sda,
/dev/disk/by-id/scsi-SATA_TOSHIBA_MK1032G_75QW2718S
  Device Number: block 8:0-8:15
  BIOS id: 0x80
  Geometry (Logical): CHS 12161/255/63
  Size: 195371568 sectors a 512 bytes
  Config Status: cfg=no, avail=yes, need=no, active=unknown
  Attached to: #16 (IDE interface)

Best regards,
- --
Renato S. Yamane
Fingerprint: 68AE A381 938A F4B9 8A23 D11A E351 5030 D420 515A PGP Server: http://pgp.mit.edu/ --> KeyID: 0xD420515A
<http://www.renatoyamane.com>
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.2 (GNU/Linux)
Comment: Using GnuPG with SUSE - http://enigmail.mozdev.org

iD8DBQFFYvOO41FQMNQgUVoRAuMsAJ4u1LyPkzwzPDIodVBJlPNi9r1JQACfYDTN LS8v5Gkofy0OZUmiABCxXHE=
=ndQX
-----END PGP SIGNATURE-----

#1 lore raw
Quoted 5 lines · Renato S. Yamane

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I receive this error message on boot with Kernel 2.6.18.3

Quoted 7 lines

relevant (I think) dmesg output:
=======
ahci 0000:00:1f.2: version 2.0
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
ACPI: PCI Interrupt 0000:00:1f.2[B] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
ahci: probe of 0000:00:1f.2 failed with error -12

"-12" is ENOMEM, which means it failed to map an MMIO resource.

Either (a) you should turn on AHCI (or RAID) in BIOS, or (b) you should not even try to load ahci driver.

Jeff