add TI DA8xx support:
v5 cover add TI DA8xx support:
Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board.
See:
http://www.ti.com http://www.spectrumdigital.com/
DA8xx is similar to DaVinci devices, but has a differing memory map and updated peripherals. It is intended that DaVinci drivers will be modified in some way to support these differences.
A side effect of this is that there are some legacy code constructs in this patch set that are required to utilize the DaVinci drivers as they stand now. For example there are some volatiles and memory pointer types defined that are no longer considered acceptable.
The new code in this patch set doesn't use these constructs and the remaining artefacts can be removed when the DaVinci drivers stop using them.
This patch set is based on code originally from TI.
---
Changes from previous patch set:
#defines of constant variables to lower case
load registers only as required in clk_get()
This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
configuration API" posted on 2009-11-04
Applies to u-boot-ti:
v5 cover add TI DA8xx support:
Quoted 22 lines · Nick Thompson
Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board.
See:
http://www.ti.com http://www.spectrumdigital.com/DA8xx is similar to DaVinci devices, but has a differing memory map and updated peripherals. It is intended that DaVinci drivers will be modified in some way to support these differences.
A side effect of this is that there are some legacy code constructs in this patch set that are required to utilize the DaVinci drivers as they stand now. For example there are some volatiles and memory pointer types defined that are no longer considered acceptable.
The new code in this patch set doesn't use these constructs and the remaining artefacts can be removed when the DaVinci drivers stop using them.
This patch set is based on code originally from TI.
---
Changes from previous patch set:
Quoted 7 lines
#defines of constant variables to lower case
load registers only as required inclk_get()This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
configuration API" posted on 2009-11-04
Yes it is dependent.
There is a compile error without the pin mux function.
Once the pin multiplex patch is ack-ed then
Ack to this patch set.
Thanks
Tom
Quoted 6 lines
Applies to u-boot-ti:
_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
v5 cover add TI DA8xx support:
Quoted 6 lines · Tom
Quoted 4 lines · Nick Thompson
Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board.
This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
configuration API" posted on 2009-11-04
Quoted 8 lines
Yes it is dependent.
There is a compile error without the pin mux function.Once the pin multiplex patch is ack-ed then
Ack to this patch set.Thanks
Tom
I've submitted an update for the pinmux functions, based on your comments.
Thanks for the Ack,
Nick.
v5 cover add TI DA8xx support:
Quoted 9 lines · Nick Thompson
Quoted 8 lines · Tom
Quoted 4 lines · Nick Thompson
Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM board.
This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
configuration API" posted on 2009-11-04Yes it is dependent.
There is a compile error without the pin mux function.
Quoted 8 lines
Quoted 5 lines
Once the pin multiplex patch is ack-ed then
Ack to this patch set.Thanks
TomI've submitted an update for the pinmux functions, based on your comments.
Yes. Your changes are fine.
Sandeep,
Can you push this the pinmux and then this change to the arm-ti ?
Tom
Quoted 2 lines
Thanks for the Ack,
Nick.
Paulraj
v5 cover add TI DA8xx support:
Quoted 26 lines
-----Original Message-----
From: Tom [mailto:Tom.Rix at windriver.com]
Sent: Thursday, November 12, 2009 8:42 AM
To: Nick Thompson; Paulraj, Sandeep
Cc: u-boot at lists.denx.de
Subject: Re: [U-Boot] [PATCH V5 0/4] add TI DA8xx support:Quoted 3 lines · Nick Thompson
Quoted 2 lines · Tom
Quoted 1 line · Nick Thompson
Add initial support for DA8xx SoC's and the spectrum digital DA830 EVM
board.
Quoted 6 lines
Quoted 6 lines
Quoted 3 lines
This patch set depends on "[PATCH V3] Davinci: add a pin multiplexer
configuration API" posted on 2009-11-04Yes it is dependent.
There is a compile error without the pin mux function.Quoted 7 lines
Quoted 5 lines
Once the pin multiplex patch is ack-ed then
Ack to this patch set.Thanks
TomI've submitted an update for the pinmux functions, based on your
Quoted 8 lines
comments.
Quoted 1 line
Yes. Your changes are fine.
Sandeep,
Can you push this the pinmux and then this change to the arm-ti ?Tom
Will do it this weekend.
Quoted 4 lines
Quoted 3 lines
Thanks for the Ack,
Nick.