Skip to contentSkip to conversation

ARM STM/i.MX: Add the reset control of LCD

PATCH In review Gregory CLEMENT 1 participant 1 message Jan 4, 2011

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

PATCH 4/4 ARM STM/i.MX: Add the reset control of LCD

Video controller of STM allow to control the reset bit of an external LCD controller. When reset_lcd is set, CTRL1_RESET bit is used to enable and disable LCD.

---
 arch/arm/mach-stm/include/mach/fb.h |    1 +
 drivers/video/stm.c                 |   11 +++++++++++
 2 files changed, 12 insertions(+), 0 deletions(-)
arch/arm/mach-stm/include/mach/fb.h +1 -0
index f899433..3d40479 100644
@@ -39,6 +39,7 @@ struct imx_fb_videomode {
 	unsigned ld_intf_width;	/**< refer STMLCDIF_* macros */
 	unsigned data_mode;
 	u32 bits_per_pixel;
+	unsigned reset_lcd; /** use LCD_RESET signal*/
 };
 
 #endif /* __MACH_FB_H */
drivers/video/stm.c +11 -0
index 3dc2abe..b1bb9b3 100644
@@ -48,6 +48,7 @@
 # define CTRL1_FIFO_CLEAR (1 << 21)
 # define SET_BYTE_PACKAGING(x) (((x) & 0xf) << 16)
 # define GET_BYTE_PACKAGING(x) (((x) >> 16) & 0xf)
+# define CTRL1_RESET (1 << 0)
 
 #ifdef CONFIG_ARCH_IMX28
 # define HW_LCDIF_CTRL2 0x20
@@ -271,6 +272,11 @@ static void stmfb_enable_controller(struct fb_info *fb_info)
 
 	/* stop FIFO reset */
 	writel(CTRL1_FIFO_CLEAR, fbi->base + HW_LCDIF_CTRL1 + BIT_CLR);
+
+	/* enable LCD using LCD_RESET signal*/
+	if (fbi->pdata->reset_lcd)
+		writel(CTRL1_RESET,  fbi->base + HW_LCDIF_CTRL1 + BIT_SET);
+
 	/* start the engine right now */
 	writel(CTRL_RUN, fbi->base + HW_LCDIF_CTRL + BIT_SET);
 }
@@ -281,6 +287,11 @@ static void stmfb_disable_controller(struct fb_info *fb_info)
 	unsigned loop;
 	uint32_t reg;
 
+
+	/* disable LCD using LCD_RESET signal*/
+	if (fbi->pdata->reset_lcd)
+		writel(CTRL1_RESET,  fbi->base + HW_LCDIF_CTRL1 + BIT_CLR);
+
 	/*
 	 * Even if we disable the controller here, it will still continue
 	 * until its FIFOs are running out of data
Signature · 8 lines
1.7.0.4



_______________________________________________
barebox mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/barebox